Miracle-Ear GO Remote User manual

GO Remote
User Manual
www.miracle-ear.com
G43015_USRB_C GO Remote User Manual.indd 1 2/12/20 12:56 PM

2
Content
Your remote control 5
Components 6
Key lock 7
Pairing hearing aids 8
Function overview 13
Further information 15
Cleaning 15
Replacing the battery 16
Troubleshooting 20
G43015_USRB_C GO Remote User Manual.indd 2 2/12/20 12:56 PM

3
Service 22
Adjusting the signal strength 23
Important safety information 25
Personal safety 25
Product safety 27
Important information 30
Intended use 30
Symbols 31
Operating, transport, and storage conditions 33
Disposal information 34
G43015_USRB_C GO Remote User Manual.indd 3 2/12/20 12:56 PM

4
G43015_USRB_C GO Remote User Manual.indd 4 2/12/20 12:56 PM

5
Your remote control
GO Remote is a remote control for hearing aids. It works
with specific Miracle-Ear hearing aids. Your Hearing Care
Specialist will consult with you on the compatible models.
CAUTION
Read this user manual thoroughly and completely
and follow the safety information in this document to
avoid damage or injury.
G43015_USRB_C GO Remote User Manual.indd 5 2/12/20 12:56 PM

6
Components
Status LED
Volume buttons
Keyring
Key lock switch
Program change button
G43015_USRB_C GO Remote User Manual.indd 6 2/12/20 12:56 PM

7
Key lock
XTo prevent any accidental
operation while the remote
control is in a pocket or
bag, move the key lock
switch to the lock position (red color visible).
When the key lock is active, all buttons on the remote
control are disabled.
G43015_USRB_C GO Remote User Manual.indd 7 2/12/20 12:56 PM

8
Pairing hearing aids
Your hearing aids need to be paired with your remote
control. After that, the pairing is saved in the hearing aids
and remembered each time they are turned on.
XLock the remote control (red color visible).
XFirst turn the hearing aids off:
Open the battery compartments. If your hearing aids do
not have a battery compartment,
turn them off as described in the hearing aids'
user manual.
G43015_USRB_C GO Remote User Manual.indd 8 2/12/20 12:56 PM

9
X
Then turn the hearing aids on:
Close the battery compartments. If your hearing aids
do not have a battery compartment, turn them on as
described in the hearing aids' user manual.
The hearing aids are now in pairing mode.
You have 3 minutes to complete the pairing.
Follow the steps on the next page.
G43015_USRB_C GO Remote User Manual.indd 9 2/12/20 12:56 PM

10
X
Insert the hearing aids into your ears.
XHold down the button on the remote control while
switching the key lock to the unlock position
(green color visible).
XRelease the button.
The remote control is now in setup mode,
the LED will be on.
While the remote control is in setup mode, do not
press or . This would change other settings.
G43015_USRB_C GO Remote User Manual.indd 10 2/12/20 12:56 PM

11
X
Hold down the button until the pairing confirmation
sound is played in the hearing aids. It takes
approximately 2 seconds for the sound to start playing.
XEnsure that the confirmation sound is heard in both
hearing aids. When heard, the pairing will be complete.
The remote control will remain in setup mode for an
additional 30 seconds. The confirmation sound can
be played again by pressing during these 30 seconds.
XTo exit the setup mode of the remote control,
wait 30 seconds or move the key lock switch to
the lock position (red color visible).
G43015_USRB_C GO Remote User Manual.indd 11 2/12/20 12:56 PM

12
When pairing is finished, the remote control is ready for
use.
XEnsure that it is unlocked (green color visible).
If the hearing aids could not be paired, refer to the
“Troubleshooting” section.
G43015_USRB_C GO Remote User Manual.indd 12 2/12/20 12:56 PM

13
Function overview
Function Description
Volume or
Press once to adjust the volume one
level at a time. Or, press and hold until
desired volume is reached.
Hearing
program
short press
Switches to the next hearing program.
G43015_USRB_C GO Remote User Manual.indd 13 2/12/20 12:56 PM

14
Function Description
Turn on/off
(standby)
and long press (2 seconds)
Turns your hearing aids
on or off.
Reset long press (2 seconds)
Switches to hearing program 1 and
sets the default volume level.
G43015_USRB_C GO Remote User Manual.indd 14 2/12/20 12:56 PM

15
Further information
Cleaning
NOTICE
XDo not put your remote control
in water!
XDo not clean your remote control
with alcohol or benzine.
XClean the remote control as necessary with a dry or
slightly damp soft cloth.
Use only distilled water to dampen the cloth.
XAvoid any cleaning agents.
G43015_USRB_C GO Remote User Manual.indd 15 2/12/20 12:56 PM

16
Replacing the battery
The remote control uses a CR 2450 button cell battery.
XSlide the battery
compartment
cover in the
direction of the
arrow .
XRemove the
empty battery
by pulling the
removal flap .
G43015_USRB_C GO Remote User Manual.indd 16 2/12/20 12:56 PM

17
Insert the battery with the "+" symbol facing up:
XSlide it under the holder,
then push it down.
G43015_USRB_C GO Remote User Manual.indd 17 2/12/20 12:56 PM

18
X
Attach the cover by sliding it onto the remote control.
G43015_USRB_C GO Remote User Manual.indd 18 2/12/20 12:56 PM

19
The pairing status is remembered by the remote control
when replacing the battery. There is no need to pair the
hearing aids again after battery replacement.
G43015_USRB_C GO Remote User Manual.indd 19 2/12/20 12:56 PM

20
Troubleshooting
If the remote control does not work:
●Ensure that the battery is inserted correctly.
Refer to section “Replacing the battery.”
●Ensure that the keys are not locked.
Refer to section “Key lock.”
●Ensure that there is nothing between the
hearing aids and the remote control.
●Increase the signal strength.
Refer to section “Adjusting the signal strength.”
●Pair the hearing aids again.
Refer to section “Pairing hearing aids.”
G43015_USRB_C GO Remote User Manual.indd 20 2/12/20 12:56 PM