Mocka Neva Cot User manual

Neva Cot
1
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Thank you for your purchase.
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters and
power points. Keep all medications, string, elastic, small toys or small items, such as
money, out of reach from any position in the cot.
Assembly
Care must be taken when attaching sides. Do not over-tighten screws as this can cause
damage to the cot.
Care and Maintenance
Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean - use a damp cloth, avoiding the use of detergents or abrasives.
Recommended mattress size
This cot has been manufactured for use with a mattress which measures 1300mm long x
mm wide x 100mm in thickness. The width and length are specified because it is
important that gaps between the mattress and the sides and ends of the cot will not
exceed 40mm
This is to minimize the risk of a child’s limb becoming
caught in the gap. The thickness of the mattress has been specified to ensure that the
depth of the cot is greater than 500mm with the mattress base in the lower position to
minimize the risk of a child climbing or falling out of the cot.
WARNING: TO PREVENT FALLS, THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP
Please follow the manufacturers assembly instructions in detail to ensure
the safety features of the cot are not comprised.
medium
screw
x8
long
screw
x12
small
screw
x8
bolt
x6
locking nut
x6
Phillips screwdriver required.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
G
washer
x4

1Bottom Position 2Upper Position
Neva Cot
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Attach panels [1] to panel [2] and secure with 8 x screws (A) and 4 x
washer (G). Tighten with an Allen Key (D).
1
1
2
A
G
G
G
G
GA
A
A
Attach panels [1] to panel [2] and secure with 8 x screws (A).
Tighten with an Allen Key (D).
1
1
2
AA
A
A

Neva Cot
Attach panels [3] and [4] to assembled frame as shown and secure with
12 x long screws (B), 6 x bolts (E) and 6 x locking nuts (F). Tighten with
an Allen Key (D) and a scewdriver. Move the unit into the desired
location. You’re done, enjoy!
3
3
4
All done! Regularly check all screws are suitably tightened. Place the
correct sie mattress into the cot before use. To clean use a damp cloth,
avoiding the use of detergents or abrasives. Once assembled lift
furniture into place, do not drag.
3
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
4

Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Neva Cot
OPTIONAL: To adjust mattress base setting, repeat steps 2 and 3 by
removing the side panel, unscrewing screw (A) and move the base to
the corresponding holes. Securely fasten again in the adjusted postion
and replace the screws, using the spare holes you took the base from.
C
5
4