Mocka Haywood Desk User manual

Haywood Desk
1
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Thank you for your purchase.
Please follow the instructions below for correct assembly.
A
Hardware Supplied
50mm screw
x16
Phillips & Flathead screwdrivers required.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
B
30mm screw
x32
C
50mm screw
x8
D
feet
x8
E F G
wall plug
x2
25mm
screw x2
safety
strap x2
WARNING: Any furniture that is not anchored to a wall has the potential to
tip over in certain circumstances, i.e. if a child attempts to climb up on the
furniture or in the event of an earthquake. Accordingly, we recommend that
all furniture is anchored to a wall. We supply a free safety wall anchor with
all furniture sold and we recommend these are used to prevent your product
tipping. The fixing device provided should fit most wall types, but please note
that different wall materials may require different fixing devices from those
supplied.
14mm
screwx2
H

1 x2 2x2
Haywood Desk
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Insert 4 x feet into legs [1] as shown and tighten. Repeat step for
second pair of legs.
Attach pipes [2] & [4] and Panel [3] to Legs [1] and secure with 12 x
screws (B) and 4 x screws (C). Tighten with a screwdriver. Repeat
step for second pair of legs.
1
1
1
1
D
D
D
D
B
B
B
B
B
B
B
B
B
C
CC
C
BB
B
3
4
4
2

3x2
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Attach panel [5] to pipe [4] and secure with 4 x screws (A). Tighten
with a screwdriver. Repeat step for second pair of legs.
Attach support pipes [6] to assembled frame as shown and secure
with 8 x screws (B). Tighten with a screwdriver.
Haywood Desk
4
A
A
A
A
4
6
6
4
5
B
BB
B
B
B
2B
2
B

5
4
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Haywood Desk
6
Attach panel [7] to assembled frame as shown and secure with 8 x
screws (A). Tighten with a screwdriver.
A
AA
AA
A
A
A
7
Move the unit into the desired location up against a wall, do not drag.
Use a drill to create a small hole lining up with the top of the 2 x safety
straps (G) and secure with 2 x wall plugs (F), and 2 x screws (E). Then
attach the safety strap with the Panel with 2 x Screw (H). Tighten with a
screwdriver. You've done, enjoy!
E
F
G
G
H
H
G