Mocka Storage Box User manual

Storage Box
1
Phillips & Flathead screwdrivers required
mocka.co.nz | mocka.com.au
| PO BOX 6171, Maroocydore BC, QLD, 4558
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
Warning: Small parts are used to assemble the Storage Box and should
only be assembled by an adult. Keep all assembly parts away from small
children. Please follow the assembly instructions correctly when install the
compression hinge to avoid finger entrapment. If the hinge is installed correctly
there will be no risk of finger entrapment.
*We recommend using a Flathead screwdriver to tighten all locking nuts 100%
before first use. Please clear any loose wood from the locking nut holes before
inserting the nut to ensure it locks 100%.

12
To assemble the Storage Box first insert 4x wood dowels (H) into each front
and back panel [2] and [3].
Fasten side panel [1] to panels [2] and [3] using 4x bolts (A) and 4x nuts
(B). Ensure the grooves on the panels all align. Tighten all bolts with a
screwdriver.
Storage Box
2
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroocydore BC, QLD, 455
8
Assembly Instructions

34
Next slide the base panel [5] into the grooved slots in the panels. Repeat Step 2. Fasten side panel [1] to panels [2] and [3] using 4x bolts
(A) and 4x nuts (B). Ensure the grooves on the panels all align. Tighten
all bolts with a screwdriver.
Storage Box
3
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroocydore BC, QLD, 455
8
Assembly Instructions

56
Attach the two brackets (E) to the spaces in panel [3] using 2x small
screws (C) in each. Tighten screws with a screwdriver.
Then fasten the Storage Box lid [4] to the brackets (E) using 2x small screws
(C) in each. Tighten screws with a screwdriver.
Storage Box
Assembly Instructions
4
mocka.co.nz | mocka.com.au
| PO BOX 6171, Maroocydore BC, QLD, 4558

Jolt Wardrobe
ASSEMBLY INSTRUCTIONS
5
78
Attach the compression hinge (F) in place using 4x screws (D). Ensure
the hinge is fastened to both lid [4] and back panel [3] using a
screwdriver. Check the lid easily opens and closes.
Ensure all screws and bolts are secure but not over tightened before
use. Finish by covering bolts holes with hardware (G). All done, enjoy!
Storage Box
Assembly Instructions
5
mocka.co.nz | mocka.com.au
| PO BOX 6171, Maroocydore BC, QLD, 4558