Mocka Kris Chair User manual

A B C D E
F G HJI
Hardware Supplied
50mm
screw x4
50mm
screw
(black) x2
80mm
screw x4
spring
washer x8
screw
pin x4
dowel
x4
allen
key x1
40mm
screw x4
Phillips screwdriver & hammer required
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
flat
washer x4
35mm
screw
(black) x2
Kris Chair
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
Attach the left and right chair legs [1] to the front and back centre rails
[2] using 2x dowels (I), 4x 50mm screws (B), 4x spring washers (E) and
4x screw pins (E) as shown. Tighten with the allen key (J). Slot the front
rail [5] and back rail [6] in between the legs.
Attach the back rest [4] to the left and right chair legs [1] using 2x 50mm
black screws (C) and 2x 35mm black screws (D). Tighten with the allen
key (J).
2
11
right left
6
5
J
BE G
I
C
DJ
4
11
f
b
f
b
front
back
Kris Chair
2
mocka.co.nz | mocka.com.au
Assembly Instructions

12
Attach the left and right chair legs [1] to the front and back centre rails
[2] using 2x dowels (I), 4x 50mm screws (B), 4x spring washers (E) and
4x screw pins (E) as shown. Tighten with the allen key (J). Slot the front
rail [5] and back rail [6] in between the legs.
Attach the back rest [4] to the left and right chair legs [1] using 2x 50mm
black screws (C) and 2x 35mm black screws (D). Tighten with the allen
key (J).
2
11
right left
6
5
J
BE G
I
C
DJ
4
11
f
b
f
b
front
back
34
Carefully turn the chair over and attach the chair seat [3] using 4x
80mm screws (A), 4x spring washers (E) and 4x flat washers (F),
tightening with the allen key (J). Secure the front rail [5] and back rail
[6] with 4x 40mm screws (H) and tighten with a screwdriver.
Carefully turn the chair over onto its legs, ensuring it is balanced and
steady before use. You’re done, enjoy!
3
H
J
A
E
F
6
5
Kris Chair
3
mocka.co.nz | mocka.com.au
Assembly Instructions