MOTECK ID11 User manual

www.moteck.com
Actuator
ID11
USER GUIDE
Technical changes may be made to improve the performance of the product without notice！
2021.05_V2.0
Revision

www.moteck.com
MOTECK MO-I-0004-V2.0
1. CAUTION
The load should be centered on the
operating direction.
Side load is NOT good for actuators.
Side load
KG
Load direction
KG
●
●
●
Be sure that the load acts on the actuator in the axial direction and it isn't recommended to have
side load acts on the actuator.
If the actuator is jammed by an obstruction or the load is severely overweight, the actuator's clutch
protection device will trip and run idly to protect the actuator or the customer's mechanical
equipment from damage. However, once the clutch trips, it will cause the actuator's stroke range to
deviate from the original factory settings and affect normal use. Please be careful to avoid
obstructions and do not exceed the rated load of the actuator. If it is found that the clutch has
tripped and the stroke setting is abnormal, immediately stop using the actuator before the
equipment is damaged, and contact the local agent or service center for assistance.
Users are forbidden to open the outer cover of the limit switch so as not to affect the original
protection level of the actuator, resulting in the immediate failure of the original factory protection
commitment.
3. Safety Declaration
2. Wire Connection
For ID11 actuators, connection rule of power wires according to the instruction below.
Connect red wire to “Vdc +” & black wire to “Vdc -“ of DC power
to extend the actuator. Switch the polarity of DC input to retract it.
Power
wires
Red
Black
Wire color Comments
This appliance cannot be used by children or persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
DC Power
Definition