MOTECK ID12 User manual

User Guide
Industrial Actuator Model: ID12
MOTORIZE OUR WORLD
R
External adjustable reed sensor
NC type (normal close)
CAUTION:CAUTION:
The load should be centered on the operating direction.
Side Load is NO good for actuators.
KG
Load
KG
Side Load
WIRE CONNECTIONWIRE CONNECTION
For ID12 actuators, connection rule of power wires varies according to different types and gear ratio(s).
Please follow the instructions below.
Standard Type
Please refer to the table below to define the actuator's extension.
Red and Black is the color of wires, M+ is "+" and M- is "-" of DC power.
With Limit Switch Type
Please refer to the table below to define the actuator's extension.
When Red (M+) is connected to "+" and Black (M-) is connected to "-" of
DC power the actuator will extend.
5:1,10:1, 20:1
30:1, 40:1
Wiring
Gear Ratio
Red
Black
M+
M-
Red
Black
M-
M+
Wiring
Red
Black
M+
M-

M1-IND-I-0001-1.0
c 2016 Moteck. Printed in Taiwan. The contents of this publication are the copyright of the publisher and may not be copied or even extracted unless prior written permission is authorized.
SAFETY DECLARATION
This appliance cannot be used by children or persons with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction.
With Potentiometer Type
Please refer to the table below to define the actuator's extension.
When Red (M+) is connected to "+" and Black (M-) is connected to "-"
of DC power the actuator will extend.
White, Yellow & Blue are positioning signal wires as shown in table.
The resistance between Blue and White wires increases when
extending, and decreases when retracting.
BW
YW
B
Y
Actuator retracting
Value of Potentiometer
Stroke(mm)
100
150
200
300
450
600
Resistance
Tolerance: 0.3 K
0.3-8.0 K
0.3-8.5 K
0.3-9.1 K
0.3-8.6 K
0.3-9.2 K
0.3-9.8 K
The Ohm value between blue and white wire
External Reed Sensors
Pick any wire of each sensor and connect them as common point, then define
the rest one as signal input.
How to change the position of reed sensor:
step 1. Loosen the screws.
step 2. Slide sensor to the correct position.
step 3. Tighten the screws and make sure the sensor is fixed.
common
point
signal
Wiring
Red
Black
M+
M-
White
Yellow
GND
VCC
Blue Data