Motorola RPX Repeater Series User manual

User Guide
HKPN4003A
RPX Repeater
Series
Vehicle Charger

1
IMPORTANT
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This document contains important safety and
operational instructions. Please read these instructions
carefully and save them for future reference.
Before using the HKPN4003A Vehicle Charger, read
all the instructions and cautionary marking on (1) the
vehicle charger (2) the battery, and (3) the RPX
Repeater. using the battery.
1. The vehicle charger should only be used in vehicles with
12 VDC – 24 VDC power system.
2. To reduce risk of injury during sudden braking or impact
while driving, secure the vehicle charger and RPX
Repeater in the vehicle.
3. To reduce risk of injury, charge only the rechargeable
Motorola authorized batteries listed in "Table 1: RPX
Series Authorized Batteries" on page 5. Other batteries
may explode, causing personal injury and damage.
4. Use of accessories not recommended by Motorola may
result in risk of fire, electric shock or injury.
!WARNINGS
WARNING

2
5. The vehicle charger and RPX Repeater may become
warm during operation, but not hot. If it becomes too hot
to touch, unplug the power cable from the power socket
immediately and discontinue its use.
6. To reduce risk of damage to the electric plug and cord,
pull by the plug rather than by the cord when
disconnecting the vehicle charger.
7. To reduce the risk of fire, electric shock, or injury, do not
operate the charger if it has been broken or damaged in
any way. Take it to a qualified Motorola sales
representative.
8. Do not disassemble the vehicle charger, it is not
repairable and replacement parts are not available.
Disassembling it may result in risk of electric shock or
fire.
9. To remove the risk of electric shock, unplug the vehicle
charger device from both the repeater and the car
cigarette lighter outlet before attempting any
maintenance or cleaning.
!WARNINGS (continued)
WARNING

3
OPERATIONAL SAFETY GUIDELINES
• This equipment is not suitable for outdoor use.
Use only in dry locations/conditions.
• Connect equipment only to an appropriately fused
and wired supply of the correct voltage (as
specified on the product).
• The cigarette lighter socket outlet to which this
equipment is connected to should be close by and
easily accessible.
• In equipment using fuses, replacements must
comply with the type and rating specified in the
equipment instructions.
• When used, maximum ambient temperature
around the charger must not exceed 60 °C
(140 °F).
• Output power from the power supply unit must not
exceed the ratings stated on the product label
located on the bottom of the vehicle charger.
• Make sure the cord is located where it will not be
stepped on, tripped over, or subjected to water,
damage, or stress.
• Do not operate the vehicle charger with a
damaged cord or cigarette lighter connector or
outlet – replace it immediately.
• Turn OFF the RPX Repeater before plugging the
vehicle charger into the 12 VDC – 24 VDC vehicle
cigarette lighter outlet.

4
VEHICLES EQUIPPED WITH AIR BAGS
• Do not place or install
equipment in the area over an
air bag or in the air bag
deployment area. Air bags
inflate with great force. If
equipment is installed in the air
bag deployment area and the
air bag inflates, the equipment
may be propelled with great
force and cause serious injury
to occupants of the vehicle.
• If the equipment is improperly
installed and the air bag
inflates, this could cause
serious injury. Installation of
vehicle communication
equipment should be
performed by a professional
installer/technician qualified in
the requirements for such
installations.
!
WARNING

5
MOTOROLA AUTHORIZED BATTERIES
Note: The batteries and Li-Ion Battery Frame Kit listed in Tables
1 and 2 below are approved for use with RPX Repeater
and the HKPN4003A Vehicle Charger.
Note: (*) These are the orderable part numbers. Authorized
batteries under these kits are:
RLN6305: 60012001001 or 6080384X63
RLN6308: 60012000001 or 6080384Y10
Table 1: RPX Series Authorized Batteries
Part Number Description
RLN6308 (*) Ultra High Capacity Li-Ion
Battery 2400 mAh
RLN6305 (*) High Capacity Li-Ion Battery
2200 mAh
Table 2: RPX Series Authorized Battery Frame
Part Number Description
HKHN4004 RPX Li-Ion Battery Frame

6
DESCRIPTION
The HKPN4003A Vehicle Charger is used for
charging the RPX Repeater (using a Li-Ion Battery
Frame P/N HKHN4004A) when inside a vehicle. The
vehicle charger includes a connector attached to the
charger.
OPERATING INSTRUCTIONS
The vehicle charger will charge only the RPX
Repeater using the Li-Ion Battery Frame P/N
HKHN4004A with the Motorola authorized battery
listed in "Table 1: RPX Series Authorized Batteries"
on page 5. Other batteries may not charge.

7
Charging Inside the Vehicle
1. Connect the vehicle charger connector into the RPX
Repeater AC/DC jack. See figure 1 below.
2. Plug the other end of the vehicle charger into the
vehicle’s cigarette lighter outlet receptacle. The Power
LED on the vehicle charger illuminates green to indicate
proper connection to a power supply. The LED will
illuminate only if the charger is properly inserted and
locked.
RPX Repeater
Vehicle Charge
r
HKPN4003A
Connect to the
vehicle cigarette
lighter outlet
or receptacle
Vehicle Charger
Connector
AC/DC
Connector
Power
LED
Figure 1. Charging Inside Vehicle

8
Note: If voltage to the vehicle cigarette lighter socket runs
through the vehicle ignition switch, make sure the ignition
switch is turned on for continuos voltage to the RPX
repeater.
Protection Fuse
The vehicle charger is equipped with a protection
fuse. Use 5 Amp/250 V, UL approved, fast acting
fuse. To replace a fuse – refer to Figure 2 below.
Cleaning
1. Use dry cloth and/or air flow to dry the charger plug in
case of fluid drip.
2. Use vacuum cleaner to remove dust from the connector
that interfaced the charger to the RPX Repeater.
Figure 2. Replacing A Fuse