© 2014 myPhone. All rights reserved. myPhone S-Line ENG
Tech specification:
•RAM Memory: 1GB
•16GB internal memory
•1800mAh battery
•input and output charger parameters: 100-2 0V AC, 50/60Hz,
150mA
-output: 5V DC, 1000mA
•Power the phone under standard conditions:
-5V DC, 500mA
•Smartphone`s weight: 138g
1.Before first use
SIM card inserting
myPhone S-Line is a mobile phone using
Dual SIM technology. Dual SIM allows you to use two mobile networks at the
same time. To insert the SIM car correctly follow the instructions:
•Turn off the phone, remove the back cover (un ermining the slot locate
in the left corner of the base of the phone with your nail) an pull out the
battery.
•Insert the SIM car into the slot following the pictures from above an
below the socket.
MICRO SIM ADAPTERS
Do not install hollow (with no car ) micro-SIM car a apter in your
smartphone. This will cause a jam. Attempt to raw jamme a apter back from
the slot can cause mechanical amage of the phone. If SIM car a apter
ea locks in the socket, you shoul contact an authorize myPhone service!
Memory card inserting
Use only memory car s compatible an approve by myPhone. Incompatible
memory car may amage itself an the evice an remove store ata.
Incompatibility of memory car can be cause by incorrect car format (micro
SD format is require ) or unsupporte car size (over 32GB). To insert the
memory car correctly follow the irections:
•Turn off the phone an take off the back cover (un ermining the slot
locate in the left corner of the base of the phone with your nail).
•The memory car slot is locate above the battery on the right.
Following the rawing insert the memory car into the slot.
Battery inserting
To insert the battery: