nedis ACON2510BK User manual

Digital to Analogue
Audio Converter
TosLink + S/PDIF →
2x RCA + 3.5mm AUX
ACON2510BK
ned.is/acon2510bk

aQuick start guide 4
cKurzanleitung 6
bGuide de démarrage rapide 9
dSnelstartgids 11
jGuida rapida all’avvio 14
hGuía de inicio rápido 16
iGuia de iniciação rápida 19
eSnabbstartsguide 21
gPika-aloitusopas 24
fHurtigguide 26
2Vejledning til hurtig start 29
kGyors beüzemelési útmutató 31
nPrzewodnik Szybki start 33
xΟδηγός γρήγορης εκκίνησης 36

1Rýchly návod 39
lRychlý návod 42
yGhid rapid de inițiere 44
1
2
4
3
5
7
6
A

4
aQuick start guide
Digital to Analogue Audio Converter ACON2510BK
For more information see the extended manual online:
ned.is/acon2510bk
Intended use
This product is a converter for coaxial or toslink digital audio to analog L/R audio.
The product is intended for indoor use only.
Any modication of the product may have consequences for safety, warranty and
proper functioning.
Specications
Product Digital to Analogue Audio Converter
Article number ACON2510BK
Dimensions (l x w x h) 51 x 41 x 26 mm
Weight 78g
Power input 5.0 VDC ; 2.0 A
Operating temperature 0 °C - 70 °C
Operating humidity 10 % – 85 % (RH)
Storage humidity -10 % – 85 % (RH)
Power consumption 0.5 W
Supported bitrates 32 kHz 24-bit
44.1 kHz 24-bit
48 kHz 24-bit
96 kHz 24-bit

5
Main parts (image A)
1R/L output
2AUX output
3Power indicator LED
4Coaxial input
5Toslink female input
6DC power port
7Power cable
Safety instructions
-
WARNING
• Ensure you have fully read and understood the instructions in this document
before you install or use the product. Keep the packaging and this document
for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective. Replace a damaged or
defective product immediately.
• Do not drop the product and avoid bumping.
• Do not expose the product to water or moisture.
• Only use the provided power cable.
• Disconnect the product from the power source and other equipment if
problems occur.
• Do not unplug the product by pulling on the cable. Always grasp the plug and
pull.
• This product may only be serviced by a qualied technician for maintenance to
reduce the risk of electric shock.
Installing the product
-
Make sure all the devices you want to connect have been switched o.
1. Plug a twin R/L cable (not included) into the R/L output A1or plug an AUX
cable or headphone (not included) into the AUX output A2.
2. Plug the other end of the cable into your audio output device.