NGS vintage artica User manual

vintage artica
USER’S MANUAL
www.ngs.eu
English iFrançais iEspañol i Deutsch i Italiano i Português iPolski

2
USER’S MANUAL
Welcome to use this Bluetooth stereo headset. Please read this user’s manual
carefully before using it.
BRIEF INTRODUCTION
VINTAGE ARTICA NGS is a stereo Bluetooth headset. It supports the following
Bluetooth profiles:
HSP: Headset Profile
HFP: Hands-free Profile
A2DP: Advanced Audio Distribution Profile
AVRCP: Audio/Video Remote Control Profile
BEFORE USING
OVERVIEW
LED Indicator
Button 1: Power ON/Off, Pause,
Play, Pairing
Button 2: Vol+ / Next
Button 3: Vol- / Back
Mini USB to charge
MIC
1
2
3
4
5
6
1
3
2
4
5
6
ON OR OFF
1~3-second press
The Blue LED will flash for 3 seconds,
that means the device is ON or OFF.
BASIC OPERATION OF HEADSET
Function Multifunction LED status Button Operating
Power on Blue flash 3secs Button 1 3 second Press
Power off Blue flash 3secs Button 1 3 second Press
Please make sure your mobile phone has Bluetooth function that can be used.
Specific pairing procedures may vary with different mobile phone. Please refer
to your mobile phone manual for further information. Steps as follows:
Pairing the headset with Bluetooth mobile phone
1. Please keep the headset and mobile phone in the range of 1 meter when
pairing.
2. Press and hold Button 1 “3 Sec” until the headset’s LED light alternately
flashes blue.
3. Start the Bluetooth function of mobile phone and search the Bluetooth
devices. After searched, select “VINTAGE ARTICA NGS”in the Bluetooth device
list.
4. According to indication, enter password or PIN No:”0000”,and press the key
of” Yes” or “confirm.
5. After successful pairing, select “VINTAGE ARTICA NGS” in the Bluetooth
device list, and press “connect”.
6. After successful connecting, the blue LED of the headset quickly blinks twice
or three times every 4 seconds.
7. Your headset now is connected.

3
USER’S MANUAL
Function LED
Charge Red always ON
Power Full N/A
VOLUME BUTTONS
LED STATUS
Power ON Blue 3 flashes
Power off Blue 3 flashes
Pairing Blue flash150ms by 1 times
Pairing OK Blue flash 10sec by 1 times
Pairing fail Blue flash 5 sec per 1 flashes after 1min power off
Back to link Blue 500ms per 1 flashes
link after 10sec per flashes
Low battery Red >3.6V 4sec per 1 flashes
3.4V power off
Calls mode Blue 5sec by 3 flashes
Call in the mode Blue/Red Blue & Red Flashes 4sec per cycle
Music mode Blue/Red Blue & Red Flashes 4sec per cycle
Volume up/down (tap + or – buttons
per level change)
Next Press for 2 seconds to go to the
next track
Back Press for 2 seconds to go to the
previous track
CHARGING THE HEADSET
First time charging
Before you use this Bluetooth headset, please charge the battery of
VINTAGE ARTICA NGS fully.
CHARGING THE BATTERY WITH USB CABLE
Step1: Insert USB charging cable into USB port of PC or into wall charger with
USB port.
Step2: Connect charging cable with the charging port of headset.
When the red light is on, the headset is charging.
When the red light is off, the headset is charged fully.
It takes about 3 hours to charge the headset fully.

4
USER’S MANUAL
CARE AND MAINTENANCE
Please read the following suggestions carefully, that will help you to fulfill any warranty
obligations and to enjoy this product for many years.
• Keep dry and don’t put it in the dump place, in case of eecting the interior circuit of
product.
• Don’t put the product under the sunlight or place hot areas. High temperature will
short the life of electronic device, destroy the battery, or distort certain plastic.
• Don’t expose the product in the cold areas. It may damage the internal circuit board.
• Don’t try to take apart the product. It may damage the product if you are not
professional.
• Don’t fall o on the oor or knock the hard substance. It may damage interior circuit.
• Don’t use intensify chemical or detergent to clean the product.
• Don’t scrap the surface with sharp things.
• In case the product doesn’t function properly, send it to the store you bought it. The
staff will help you to solve the problem.
SPECIFICATIONS
If at any time in the future you should need to dispose of this product please note that:
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist.
Check with your Local Authority or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)
WARRANTY
Limited warranty. NGS warrants that any hardware products accompanying this documentation shall be free
from significant defects in material and workmanship for a period of two (2) years, three (3) years or five
(5) years from the date of purchase. NGS’s limited warranty is non-transferable and is limited to the original
purchaser. This warranty gives you specific legal rights, and you may also have other rights, which vary under
local laws.
Remedies. NGS’s entire liability and the user’s exclusive remedy for any breach of warranty shall be, at NGS’s
option, to: (a) repair or replace the hardware, or (b) refund the price paid, provided that the hardware is
returned to the point of purchase or such other place as NGS may direct, with a copy of the sales receipt. Any
replacement hardware will be warranted for the remainder of the original warranty period. These remedies
are void if failure of the hardware has resulted from accident, abuse, misapplication, or any unauthorized
repair, modification or disassembly. Besides, as it regards wireless devices, such remedies are void if the
batteries used are different from those recommended by NGS. On request of NGS, the user shall provide a
dated proof of original purchase or a dated summary invoice.
Disclaimer of warranty. The warranties expressly set forth in this agreement replace all other warranties. NGS
and its suppliers expressly disclaim all other warranties, including, but not limited to, the implied warranties
of merchantability and fitness for a particular purpose and noninfringement of third-party rights with
respect to the hardware, software, documentation and any other materials provided by NGS or its suppliers,
and any warranties of non-interference or accuracy of informational content. No NGS dealer, agent, or
employee is authorized to make any modification, extension, or addition to this warranty. Some jurisdictions
do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
Limitation of liability. In no event will NGS or its suppliers be liable for any costs of procurement of substitute
products or services, lost profits, loss of information or data, or any other special, indirect, consequential, or
incidental damages arising in any way out of the sale of, use of, or inability to use any NGS product or service,
even if NGS has been advised of the possibility of such damages. In no case shall NGS and its suppliers’
total liability exceed the actual money paid for the NGS producer or service giving rise to the liability Some
jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. The above limitations will not apply in case of personal injury
where and to the extent that applicable law requires such liability.
Returns Procedure. Any item to be returned or exchanged, other then those that are processed through the
seller or dealer for services, please directly contact NGS. You will find NGS disclaimer’s address and phone
numbers on the provided documentation, and on NGS website www.ngs.eu.
Bluetooth compliance Bluetooth 2.1+EDR, Specification 2.4 GHz ISM Band
Supported Bluetooth profiles Bluetooth Hands-Free Profile and
Bluetooth Headset Profile
Profile A2DP, AVRCP, Headset, Hands-Free
Frequency response 20Hz ~ 20kHz
Bluetooth class Class2
Paired device 1
Music time Up to 8 hours
Talking time Up to 15.0 hours
Standby time Up to 210 hours
Battery type 3.7V 350mA Lithium polymer battery
Charging time Up to 2-3 hours
Default password/PIN code “0000”

5
MANUEL DE L’UTILISATEUR
Bienvenue dans l’utilisation de ce casque stéréo Bluetooth. Veuillez lire
attentivement ce manuel d’utilisation avant de l’utiliser.
BRÈVE INTRODUCTION
VINTAGE ARTICA NGS est un casque stéréo Bluetooth. Il supporte les profils
Bluetooth suivants:
HSP : Profil du casque
HFP : Profil mains libres
A2DP : Advanced Audio Distribution Profile (Profil de distribution audio avancé)
AVRCP : Profil télécommande Audio/Vidéo
AVANT UTILISATION
APERÇU
Voyant LED
Bouton 1 : Bouton d’allumage ON/OFF,
pause, lecture, couplage
Bouton 2 : Vol+ / Avance
Bouton 3 : Vol- / Retour
Mini USB pour charger
Micro
1
2
3
4
5
6
1
3
2
4
5
6
ON OU OFF
appuyer pendant 1~3 secondes
Le voyant LED bleu clignote pendant 3
secondes, ce qui signifie que le dispositif
est allumé ou éteint.
FONCTIONNEMENT BASIQUE DU CASQUE
Fonctionnement Statut du voyant LED multifonctions Bouton Fonctionnement
Allumer Le voyant bleu clignote pendant 3
secondes Bouton 1 Appuyer pendant 3 secondes
Power off
(Éteindre) Le voyant bleu clignote pendant 3 secondes Bouton 1 Appuyer pendant 3 secondes
Veuillez vous assurer que votre téléphone portable comporte une fonction
Bluetooth pouvant être utilisée. Les procédures d’accouplage spécifiques peuvent
varier avec différents téléphones portables. Veuillez vous référer au manuel de
votre téléphone portable pour plus d’informations. Procédez comme suit:
Accoupler le casque avec le téléphone portable Bluetooth
1. Veuillez garder le casque et le téléphone portable dans une portée d’1 mètre
lors de l’accouplage.
2. Appuyer pendant 3 secondes le bouton 1 jusqu’à ce que le voyant LED bleu
clignote.
3. Démarrez la fonction Bluetooth du téléphone portable et cherchez les
périphériques Bluetooth. Puis, sélectionnez «VINTAGE ARTICA NGS» dans la
liste des périphériques Bluetooth.
4. Conformément aux indications, saisissez le mot de passe ou le PIN N° «0000»
puis appuyez sur la touche «Oui» ou «Confirmer».
5. Après avoir réussi l’accouplage, sélectionnez «VINTAGE ARTICA NGS» dans la
liste des périphériques Bluetooth et appuyez sur «connecter».
6. Après avoir réussi la connexion, la LED bleue du casque clignote rapidement
deux ou trois fois toutes les 4 secondes.
7. Le couplage de votre casque est réalisé.