Noble House Home Furnishings Club Chair User manual

Label Picture Description QTY
A Seat 1
B Chair Leg 4
Assembly Instructions
Caution : You must read this before you proceed
CLUB CHAIR
Part List
Noble House Home Furnishings LLC Page 1 OF 5

C Seat Cushion 1
D Back Pillow 1
Label Picture Description QTY
①Bolt (M6*15mm) 17
②Washer 17
③Allen Key 1
Before
Beginning
Assembly:
Hardware
Assembly Preparation
x17
x17
Noble House Home Furnishings LLC Page 2 OF 5

Step 1
Open the carton and place all the parts onto a clean, non-marring surface.
Place Seat(A) facedown as shown in picture above.
Align Chair Leg(B) with mounting positions on the base of the Seat(A).
Attach Chair Leg(B) to Seat(A) using Bolts(①) and Washers(②) with Allen Key(③)
as shown in the picture.
Note: The bottom of the Leg should be angled outwards.
Do not fully tighten the Bolts.
With the same process to assemble the remaining 3 Legs.
Assembly Steps
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Chair parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
FRONT FACING
Back Pillow(D)
Seat Cushion(C)
Seat(A)
Chair Leg(B)
Noble House Home Furnishings LLC Page 3 OF 5

Place the Seat Cushion(C) & Back Pillow(D) onto the Chair.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Step 2
Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles, carefully sit down on the Chair This action should allow all of the gaps
to reach full alignment status.
When the Chair is level proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
Step 3
C
D
Noble House Home Furnishings LLC Page 4 OF 5

Noble House Home Furnishings LLC Page 5 OF 5