Noble House Home Furnishings Barstool User manual

Please look in the Leg Frame for Hardware packs
Caution: This Barstool is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Barstool and to prevent any possible damage to it,
two adults are required to execute these actions.
Assembly Instructions
Barstool
Caution: You must read this before you proceed
Noble House Home Furnishings LLC
1

Label Picture Description QTY
A Seat Panel 1
B Leg Frame 2
C Leg Support Bar 2
D Seat Support Bar 1
Label Picture Description QTY
①Screw
(M6x45mm) 5
②Bolt (M6x15mm) 5
③Bolt (M6x45mm) 5
④Washer
(M6.5/16x1mm) 5
⑤Allen Key 1
Part List
Hardware
Noble House Home Furnishings LLC
2

Assembly Preparation
Before Beginning Assembly:
Noble House Home Furnishings LLC
3

Assembly Steps
Step 1
Unpack and place all parts on a clean, non-marring surface.
Overview
This Barstool has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Barstool parts, the above picture is
to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
Seat Panel (A)
Leg Support Bar (C)
Leg Frame (B)
Seat Support Bar (D)
FRONT FACING
Noble House Home Furnishings LLC
4

Align the Leg Support Bar(D) to the Leg Frame(B) as shown in the above
picture.
Attach the Leg Support Bar(D) to the Leg Frame(B) using 4 Bolts(②), 4
Washers(
④
) and the Allen Key(
⑤
) as shown in the above picture.
Do not fully tighten Bolts.
Step 2
With assistance from your adult partner, attach the Leg Support Bar(C) to the
Leg Frame(B) using 4 Screws(
①
) and the Allen Key(
⑤
) as shown in the
above picture.
Do not fully tighten Screws.
Step 3
Noble House Home Furnishings LLC
5

Place the Seat Panel(A) onto a table or a box as shown in the above picture.
You will have the Barstool bottom and legs facing up.
Attach the Leg Frame(B) to the Seat Panel(A) using 4 Bolts(③) and the Allen
Key(⑤) as shown in the above picture.
Do not fully tighten Bolts.
Step 4
Noble House Home Furnishings LLC
6

Step 4
With the assistance from your adult partner, stand the Barstool up.
Inspect it and make sure all parts are adequately connected.
Carefully sit onto the Barstool. This pressure will help align all parts at all joints.
Then get off the Barstool and proceed to tighten the Bolts and Screws in a
sequential manner.
When tightening the Bolts and Screws tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on towards the
next one.
If there are any wobbles after tightening, loosen the Bolts and Screws
and execute this same process.
Adjust the Levellers until the Barstool is level with the ground.
To adjust the Levellers, get assistance from an adult partner to lift/lean
and hold the Barstool while you are working.
Your Barstool is ready for use.
This Barstool can only be used on a flat, level surface.
Adjust Pre-installed
Levellers height for balance
Adjust high for balance Adjust low for balance
Noble House Home Furnishings LLC
7

Noble House Home Furnishings LLC
8