Noble House Home Furnishings Chair User manual

CAUTION: You must read this Assembly Instructions before
you proceed.
CAUTION : This Chair is NOT a TOY.
Keep your child / children at bay in the process of assembly.
For turning the Chair and to prevent damage to the Chair, 02 persons may
be needed to execute this action.
Please look under the Seat Panel for hardware pack.
CHAIR
Noble House Home Furnishings LLC
Page 1 OF 8

Label Picture Description QTY
ALeft Side Panel 1
BRight Side Panel 1
CSeat Panel 1
DBackrest Panel 1
ESeat Cushion 1
FBack Cushion 1
Label Picture Description QTY
①Short Bolt (M6x40x15mm) 7
②Long Bolt (M6x55x15mm) 5
③
Self Tapping Screws (M4x 35mm) 2
④
Allen Wrench (K4) 2
⑤
Screwdriver (not provided) 1
Parts List
Hardware
Noble House Home Furnishings LLC
Page 2 OF 8

This Chair has multiple parts and may require up to some 30 minutes to assemble.
To give you an overview of the Chair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Assembly Preparation
Assembly steps
Overview
Before Beginning Assembly:
FRONT FACING
Noble House Home Furnishings LLC
Page 3 OF 8

Step 1
Step 2
Unpack and place all parts on a clean, non-marring surface.
Place the Left Side Panel (A) facedown on a clean, non-marring surface as shown
above.
With assistance from your adult partner, align the mounting on the Seat Panel (C) to
the opening on the Left Side Panel (A), then secure them together using Bolts (①)
and the Allen Wrench (④) as shown above.
Do not fully tighten the Bolts at this time.
Noble House Home Furnishings LLC
Page 4 OF 8

Step 3
Step 4
With assistance from your adult partner, attach the assembled part from step 3 to
the Right Side Panel (B) using Bolts (①), Bolts (②) and the Allen Wrench (④) as
shown in the picture above.
Do not fully tighten the Bolts at this time.
With assistance from your adult partner, align the mounting of the Backrest Panel
(D) to the opening on the Left Side Panel (A), then secure them using Bolts (②) and
the Allen Wrench (④) as shown above.
Do not fully tighten the Bolts at this time.
Noble House Home Furnishings LLC
Page 5 OF 8

Step 5
Step 6
Turn the Chair right side up.
EXERT pressure, floorwards, onto the Chair with both hands.
This pressure will help the Chair reach full alignment at all joints.
Check for wobbles.
Inspect the Chair and make sure all parts are adequately connected.
Then in a sequential manner, tighten ALL Bolts and Screws at ALL joints.
Then align the Seat Panel (C) and the Backrest Panel (D) using the Self Tapping
Screws (③) as shown in the picture above.
Do not fully tighten the Screws at this time.
Adjust Pre-installed Levelers
height for balance
Adjust high
for balance
Adjust low for
balance
Noble House Home Furnishings LLC
Page 6 OF 8

Step 7
Place the Seat Cushion (E) onto the Chair and affix the magic tape straps around
the Chair as shown above.
Then place the Back Cushion (F) onto the Chair.
Your Chair is ready to be used.
This Chair can only be used on a flat, level surface.
Noble House Home Furnishings LLC
Page 7 OF 8

Care & Maintenance
Noble House Home Furnishings LLC
Page 8 OF 8