NRS Healthcare M15691 User manual

Figure 2 – Assembling the cross bar
Figure 1 – In Use
User Instrucons
Over Bed/Chair Table
General Safety Warning
Please ensure these instructions are fully read and
implemented. Failure to do so may result in injury.
Retain these instructions in a safe place for future
reference.
1.0 Intended Use
Designed for use when sitting in either a chair or
bed these tables provide an adjustable height flat
surface for reading, writing, eating etc. The table
top can be tilted for increased comfort during use.
2.0 Safety Precautions
Do not overload the table top, 5kg Max Load.
Check handwheels are secure at regular intervals.
Do not attempt to use the table as a walking aid.
Do not attempt to sit or stand on the table.
3.0 Unpacking
Remove packaging and check all parts carefully
before assembling the product. Do not assemble if
any parts are missing or damaged.
Contents:
Table Leg (M15691 only with castors) X 2
Cross Bar (with castors) X 1
Table Top X 1
Telescopic Tube X 2
Hand Wheel – Long X 2
Hand Wheel – Short X2
4.0 Assembly
4.1 Frame Assembly:
Position the cross brace over the two side frames
as shown in figue 2.
Secure by inserting and tightening the two long
hand wheels.
M15691
Wheeled
M01278
Divan Style
Figure 3 – Assembling the Table Top

NRS Healthcare is a Leading Supplier of Community Equipment and
Daily Living Aids, to view our full range, visit our website:
www.nrshealthcare.co.uk
UI/M15691, M01278/06/18/Iss4
NRS Healthcare
Sherwood House, Cartwright Way,
Forest Business park, Bardon Hill,
Coalville, Leicestershire, LE67 1UB, UK
Tel. Head Office: 0330 100 0098
Tel. Customer Services: 0345 121 8111
Email: custom[email protected]
6.0 Cleaning
Clean regularly using a general purpose, neutral
detergent and warm water.
Please check the suitability of the cleaning product
before use. Do not use abrasive cleaners or cloths
as these could permanently damage the surface and
invalidate any warranty.
Allow the product to dry thoroughly prior to use or
storage.
Always check local authority guidelines for additional
advice regards cleaning healthcare products.
7.0 Maintenance
Check castors are securely fitted and are free to
rotate. Remove any build-up of dirt/debris.
Check the height and tilt adjustment operates
correctly and the hand wheels are tight.
Inspect product regularly for signs of wear. Any
suspected faults or damage should immediately be
reported to the supplier and the product taken out of
use.
8.0 Product Disposal
Product should be thoroughly cleaned prior to
disposal.
Product is manufactured from metal, plastic and
wood and can be disposed of through Local Authority
Household Waste and Recycling Centres or through
Local Trade Waste Collectors.
9.0 Product Guarantee
NRS Healthcare guarantee this product for a period
of 12 months, from the date of purchase, against
faulty materials and workmanship. This guarantee
does not cover; abuse, misuse, interference or
tampering with any part of the product.
Any guarantee issued by NRS Healthcare does not
affect your statutory rights.
4.2 Table Top Assembly:
Turn the table top upside down and lay flat.
Slide the two silver telescopic tubes through the
brackets. Lead with the end which has a single
button clip.
Depress the button clip to enable correct
engagement through the brackets, figure 3. Ensure
it fully clicks into place on the far side of the second
bracket.
4.3 Connect the Table Top to the Base:
Insert the silver telescopic tubes into the open ends
of the two side frames.
Push down gently on the table top.
Secure by inserting and tightening the two short
hand wheels, figure 3.
5.0 Using the Table
5.1. To Adjust the Height
Loosen both of the handwheels at the top of the two
black side frames by turning anti-clockwise.
Lift the table top up or push down gently to move it
to the required height.
Tighten the two handwheels by turning clockwise to
secure in position.
5.2 To Adjust the Angle
Please Note: The table top can be tilted towards
the user to a maximum of 45°.
Loosen the handwheel at the top of the black side
frame furthest away from the user.
Lift the far edge of the table top or push down gently
to increase/decrease the angle of tilt.
5.3 Operating the Brakes
The ‘rear’ 2 castors are fitted with brakes.
To apply: firmly push the brake lever down until it
clicks into position.
To release: lift the brake lever up until the castor is
free to rotate.