Nucraft Approach User manual

Approach Installation Instructions

Before Beginning Installation
•Read through the entire instruction thoroughly
•A minimum of 2 persons is required for this assembly
•These instructions reflect typical assemblies. They may not match your
specific configuration.

Required Tools
•#3 Phillips Head Bit or Driver
•5/16 Allen Wrench
•Provided Hardware:
HW8017 Bolts
HW0543 Screws

Step 1: Leg to Base
•Remove base from packaging and
stand on square plates
•Remove bolts (12) and washers
(12) that are used to fasten legs.
•Remove legs from packaging and
align holes on center of legs to
holes in base.
Note: The glides must be facing
towards the inside of the base
after assembly.
•Fasten legs by replacing the bolts
and washers.

Step 2: Base to Top
•Remove top from packaging, and
place onto a shipping blanket to
ensure no damage to top.
Note: When base is assembled to
top, the orientation of the door
needs to face the tilt activation
lever.
•Place square plates into tilt
mechanism. Take care to NOT
damage the underside of table.
•Fasten screws (4) at both tilt
mechanism connection points,
totaling 8 screws, to attach the
base to the top.

Typical Table Labeling
See example on the next page of typical labeling for a grain matched set. Each
top will have 2 letters that are used to match the correct sides to their
corresponding partners.
• “A” will match to the corresponding “A”, “B” will match to the corresponding
“B”, and so on..