Nucraft Myne User manual

Myne Installation Instructions
ID:

Before Beginning Installation
•Read through the entire instruction thoroughly
•A minimum of 2 persons is required for this assembly
•These instructions reflect typical assemblies. They may not match your specific configuration.

Required Tools
•Drill Dri er
•#2 Phillips Head Bit
•5/32 Allen Wrench
•13mm Wrench or 13 mm socket/ratchet (x2)
•3/8 Allen Extension (pro ided)
•Hardware
–HW8883
–HW0747

Myne

Myne Exploded View
1. Top
2. Base Leg
3. Base Feet
4. Casters
5. Flip Mechanism
6. Flip Arm
7. Flip Bar
8. Ganging Connectors
1
2
3
4
5
6
7
8

Step 1: Base Structure
•Begin with the base frame upside down.
•Secure the feet to leg, through the center of the foot, with two HW8883 bolts each. A 3/8 Allen extension is pro ided
for easier access.
•Note: Casters will already be secured in place on the feet.

Step 2: Top
•Screw the arms to the underside of the work surface with HW0747. There are pilot holes in the work
surface for aligning the arms.
•Be sure the ganging connectors are to the front of the table, and the nesting handle is to the back of
the table.

Step 3: Modesty Panel (if applicable)
Secure modesty by screwing (HW0664) from the mounting hook to the predrilled holes on the underside
of the work surface.

Step 5: Powered Tables (if applicable)
•To connect power form one table to another, jumpers are used.
–Remo e plate on base to connect the jumpers to the duplexes inside the table.
–When replacing the place, the jumper will run through the mouse hole.
–For wire management use pro ided hooks.

Step 6a: DC Unit Installation (if applicable)
Using the hardware pro ided and a #2 Phillips dri er attach the DC Unit to the underside of the top. There
are pilot holes in the work surface for alignment.

Step 6b: DC Unit Installation (if applicable)
Insert wire connection into DC unit to connect table to power.

Step 7: Battery Powered Charging Cap
Battery Powered Charging Cap Cord Plug-Ins:
•The MYB-USB1 has 2 chords, and the MYB-
USB2 has 3 chords that will plug into the DC
unit.
•The cords will run through the center beam
of the table and out of the center cord pass
through.
•The chords with the smaller plug will go into
port 1 and 2.
–Both ports can take either of the
smaller cord plugs.
•The chord with the large plug will go into the
circled port.
–This cord must be plugged into this
port specifically.

Step 8: Partition Panel (if applicable)
•Center Partition on the table and slide clamps onto front edge of the work surface.
•Tighten thumb screws to secure in place.
NOTE: Partition can be installed in either the up or down position.