Omix-Ada 11232.25 User manual

Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
1
3
2
Hardware (Qty)
4. Hex Head Cap Screw M8x16
5. Button Head Socket Cap Screw
6. Hex Lock Nut M8
7. Washer M8
(6)
(2)
(2)
(6)
Page 1/3
11232.25
6
4
7
5
JEEP JK Windshield LED Light Bar
LED lights not included.
This JK lightbar is compatible with many 13.5 inch LED designs, however,
we recommend using Rugged Ridge® LED SKU: 15209.11 for best results
NOTICE
Components
1. Crossbar
2. Bracket LH
3. Bracket RH
(Qty)
(1)
(1)
(1)

Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
11232.25
Page 2/3
Installer is responsible for ensuring adequate silicone is used and applied correctly to all tub-
ing joints, bolt locations and wire grommets. Apply an even bead of silicone on the inside of
the female end. Insert the male end into tube. Silicone may also be used under bolt heads
and nuts for additional weatherproong. The following symbol is a reminder:
When running wire leads during steps 1-3,
use pre-drilled holes in the left windshield
bracket and front crossbar, shown in red
below. Use the three holes that work best
with your LEDs.
NOTICE
NOTICE
JK Windshield LED Light Bar, 07-14 Jeep

Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Page 3/3
2. Attach left and right brackets to front crossbar with
supplied M10x60 bolt and nylon lock nut. Do not tighten
completely to allow for adjustment.
4. Install front crossbar assembly to vehicle using factory
hardware. Adjust tment if necessary and securely tighten
all bolts.
CAUTION
!
Use of tape on the a-piillar, cowl, and fender
is recommended to prevent damage to
vehicle’s nish.
Two people are also recommended for this
step: One on each side.
11232.25
1. Attach 13.5 inch LED bars to the crossbar. M8x16mm
hex bolts with washer are supplied for mounting Rugged
Ridge® LEDs. Use holes in front of crossbar and underside of
LH widshield bracket for routing wires.
JK Windshield LED Light Bar, 07-14 Jeep
If other manufacturers’ lights are used,
additonal hardware may be required.
NOTICE
3. Remove the factory left and right windshield brackets.
Retain factory hardware for later use.