Omlet Eglu Cube User manual

If you have any problems assembling your Eglu Cube
call us on 0845 450 20 56 or email [email protected]
www.omlet.co.uk
Step A - Connect the Run Frame together
Lay the Frame sections on the ground infront of the Eglu Cube. The
curved section of the Frame simply slides onto the two side pieces.
Line up the frame with the run making sure that the flat sides of the
tube ends are against the inside of the run.
Also ensure that the hole in the tube is half way along the first
rectangle in the mesh.
Firstly unclip the end of your fully assembled run.
Omlet Limited
Unit 4 Tuthill Park
Wardington
Oxon OX17 1RY
www.omlet.co.uk
[email protected]
0845 450 20 56
What you have received:
Eglu Cube Run Extension
Instructions
Run Panel Side
Large x2
Run Panel
Top x1
Run Frame
Middle x1
Run Frame
Leg x2
Fastener
Pack x1

Step B - Attach the Frame to the Run
Attach both ends of the frame
loosely to the run using the
following: Small Bolt, Large Washer
and Wingnut.
Step D - Attach Extension Panels
You can now clip the Large
Side Panels and Roof Panel
sections of your extension,
putting the clips in the
positions shown.
Clip the end of your run back
on again.
Step C - Swing the Frame into position
Swing the Frame into a vertical
position. Secure the Frame in place
using two zip ties in the positions
shown by a
To ensure the frame does not change
position ensure the wingnuts are nice
and tight.
www.omlet.co.uk
If you have any problems assembling your Eglu Cube
call us on 0845 450 20 56 or email [email protected]