Omlet Rabbit to Chicken Eglu Conversion Kit User manual

Page1
Omlet Limited
Tuthill Park
Wardington
Oxon OX17 1RR
www.omlet.co.uk
[email protected]
Helpdesk: 0845 450 20 56
Rabbit to Chicken
Eglu Conversion Kit
What you have received
A Phillips ScrewdriverAround 20 minutes
Other things you will need
Chicken Base
Droppings Tray
M6 Washers
Front Face Screws
Stabilising Screws
Chicken Guide
Roosting Racks

Page2
a. Remove the two screws and washers in
the front of the front face.
b. Remove the two screws holding the
front face to the base.
Step 1 - Remove Screws And Washers From Front Face
NOTE: Please take care when tightening and untightening the screws. Be careful not to damage
the head of the screw. TIP - Press hard when screwing and unscrewing.
Remove the Rabbit Base. At this point the
locking bar will fall free.
Slot the Chicken Base onto the Front
Face.
Step 2 - Exchange Rabbit Base for Chicken Base
Step 3 - Insert Locking Bar And Do Up Front Screws
a.
b.
a. Slide the locking bar through the slot.
b. Replace the two screws and washers in
the front of the front face.
a.
b.

Page3
Step 4 - Tighten Front Face Screws
Tighten the screws until the faces in the
circle butt up against each other.
Tighten
Step 5 - Replace Screws Holding Front Face to Base
Pull back on the front face while replacing
the two screws. Stop turning the screws
as soon as they become tight so as not to
damage the thread. Pull
Step 6 - Roost Racks And Droppings Tray
Insert the two roost racks and the
dropping tray. Make sure that the clip on
the underside of the tray ‘clicks’ into place
everytime you put the tray in.
Your chickens are now ready to move in!
If you have any problems converting your eglu call us on
0845 450 20 56 or email [email protected]