Panasonic EH-HS70 User manual

© Panasonic Electric Works (Thailand) Co., Ltd.
2010. All rights reserved. Unauthorized copying and
distribution is a violation of law.
Order Number PEWT1007A88CE
Platinum Minus Ion Hair Straightener
Model No. EH-HS70
EH-HS80
Asia
Middle East
TABLE OF CONTENTS
PAGE PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 5
5 Wiring Connection Diagram ---------------------------------10
6 Schematic Diagram ---------------------------------------------11
7 Exploded View and Replacement Parts List -----------12

2
1Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100°F / 600°C).
2 Specifications

3
3 Troubleshooting Guide
(Refer to Wiring Connection Diagram)

4

5
4 Disassembly and Assembly Instructions
4.1. Disassembly Instructions
1. Remove 5 Screws at Press Plate Cover by Phillips
screwdriver (Plus Driver).
2. Remove Press Plate Cover by Slotted screwdriver (Minus
Driver). Remove it from around hook, as seen in Figure
below.
3. Remove Electrification Board assy by Slotted screwdriver
(Minus Driver).
4. Take off Shaft Cover by Slotted screwdriver (Minus
Driver).
5. Remove screws at Shaft by Phillips screwdriver (Plus
Driver).
6. Push out and remove Shaft by tiny Phillips screwdriver
(Plus Driver).
7. Remove 4 Screws of Heater Side by Phillips screwdriver
(Plus Driver).

6
8. Remove 1 Screw at Housing B by Phillips screwdriver
(Plus Driver).
9. Remove 2 Screws at Housing B by Phillips screwdriver
(Plus Driver).
10. Take off Housing A and Housing B as follows below.

7
4.2. Assembly and Disassembly Points
1. HV Circuit Board Assembly Point.
2. Platinum negative Ion b/k Assembly Point.
3. Lead Wire Arrange Points.

8
4. Shaft Cover fixing point.
5. Points of Ion charge panel assembly and Installment of
Charging wire.
6. Housing B assembly point

9
7. The sticking point for a insulation tape.
8. Shaft Cover Has a Direction, as below.
9. Press Plate side lead wire arrangement.

10
5 Wiring Connection Diagram