PDQ KMS pdqSMART User manual

KMS pdqSMART INSTALLATION INSTRUCTION
CYLINDRICAL DEADBOLT
ALL KMS - EXCLUDING STS
4. INSTALL GASKET & INSIDE
MOUNTING PLATE
 Route wire through slot in bottom of
gasket and mounting plate
 Install rubber gasket and inside mounting
plate and secure with (2) #10-32 x
1-7/16" flat head screws.
2. INSTALL OUTSIDE TRIM
ASSEMBLY
 Install escutcheon/chassis assembly from
outside of door – feeding reader wire
through chassis hole in door – under latch.
 Retract deadbolt -
Left Hand Door – Rotate tailpiece
clockwise until it stops in the vertical
orientation.
Right Hand Door – Rotate tailpiece
counter-clockwise until it stops in the
vertical orientation.
I4704 Rev2 – 5/22/20
1. PREPARE DOOR &
INSTALL LATCH
 Prepare door according to template.
 Install latch with cross slot for tailpiece
toward bottom.
 Secure with (2) #8 x ¾” combo screws.
Phone: [phone] | www.pdqlocks.com

KMS pdqSMART INSTALLATION INSTRUCTION
I4704 Rev2 – 5/22/20
5. INSTALL INSIDE TRIM AND
BATTERIES
 Plug reader wire into socket on control
board on back of escutcheon, route wire
through hook in mounting plate as
shown, install escutcheon onto door.
Take care to keep from pinching wire.
Verify that thumb turn properly operates
deadbolt latch.
 Secure escutcheon with (2) M4x12 Pan
head screws.
 Install batteries and battery cover with
M3x18 pan head screw.
WIRE ROUTING
BATTERY
COVER
READER
SOCKET