PDQ pdqSMART SDS User manual

RH/RHRLH/LHR
SDS pdqSMART INSTALLATION INSTRUCTION
CYLINDRICAL LOCK
1. CHECK HANDING OF LOCK
 If handing of lock is not correct for opening, see next
page for handing instructions.
3. INSTALL OUTSIDE TRIM /
CHASSIS ASSEMBLY
 Install escutcheon/chassis assembly from
outside of door – feeding wires through
chassis hole in door.
2. PREPARE DOOR &
INSTALL LATCH
 Prepare door according to template.
 Install latch, radius toward door frame
 Secure with (2) #8 x ¾” combo screws.
4. INSTALL INSIDE
MOUNTING PLATE
 Install inside mounting plate and
secure with (2) #10-32 x 1-7/16" flat
head screws.
88328 Rev2 – 7/22/20
READER
WIRE
CHASSIS
WIRE
Phone: [phone] | www.pdqlocks.com

SDS pdqSMART INSTALLATION INSTRUCTION
88328 Rev2 – 7/22/20
REMOVE
TAPE
LEVER PICK
5. CONNECT READER AND
INSTALL INSIDE TRIM
 Plug reader wire and chassis wire into
sockets on control board on back of
escutcheon, install escutcheon onto
door. Be careful not to pinch wires.
 Secure escutcheon with (2) M4 x 12 Pan
head screws.
 Install batteries and battery cover with
M3 x 12 pan head screw.
 Install lever ring and inside lever – push
until lever retaining clip clicks into place.
BATTERY
COVER
INSIDE
LEVER
REMOVE
AND
ROTATE
CHASSIS
LEVER
RING
READER
SOCKET
CHASSIS
SOCKET
Standard Cylinder HANDING INSTRUCTIONS
1. Remove outside lever:
Standard Cylinder - Use supplied pick in hole on
front of lever. Lever cannot be removed with pick until
key is inserted and turned 45 degrees.
Interchangable Core – Remove core from outside
lever with Control Key, Using small screwdriver or
awl, pull back lever clip from inside as shown.
2. Remove tape holding wire to chassis.
3. Pull chassis out of escutcheon and rotate chassis 1/2
turn (180°) maximum.
4. Replace chassis and attach tape.
5. Re-install lever -
Standard: Rotate key while installing / IC: Insert Core
Interchangable Core
REMOVE CORE,
PULL BACK CLIP
WITH SCREWDRIVER
HERE