6 1-800-732-2677 (US), 1-800-457-3911 (Canada)
Step 4: Attach the SmartKey™to the Pet’s Collar
Thread your pet’s collar through the SmartKey’s attachment
loop.Your pet’s collar must be ¾" wide or less.The
SmartKey should hang under the pet’s neck.
If your pet’s collar is too large to thread through the key, a
key ring has been provided for use for attachment to your
pet’s collar ring.
__________________________________________________________________________________________
Using Your Electronic SmartDoor™
Locked Mode
The Electronic SmartDoor ships from the factory in the Locked mode.The Electronic SmartDoor will
enter Locked mode when the 4 D-cell batteries are placed in the Battery Box.
To enter Locked mode when the Electronic SmartDoor is in either the Unlocked or Automatic
mode, press and hold the Mode/Reset button until the red LED is illuminated.While the red LED is
illuminated, release the Mode/Reset button.The flap is locked.
Entering Unlocked Mode
To enter Unlocked mode, press and hold the Mode/Reset button; the red LED will illuminate
indicating Locked mode, then the green LED will illuminate.While the green LED is illuminated,
release the Mode/Reset button.The flap will unlock.
Automatic Mode
To enter Automatic mode, press and hold the Mode/Reset button; the green LED will illuminate
indicating Unlocked mode, then the yellow LED will illuminate.While the yellow LED is illuminated,
release the Mode/Reset button.The flap will enter Automatic mode.The flap will move down (locking)
and the Electronic SmartDoor will seek the presence of the SmartKey. When the unit senses the
SmartKey, the flap will unlock.When the SmartKey signal is no longer detected, the flap will lock.The
SmartKey signal must be out of range of the Electronic SmartDoor for 10 seconds before the door will
respond to the SmartKey signal again.
Learning Mode
To enter Learn mode, press and hold the Learn button until the green LED begins to flash. Release the
button. Bring the SmartKey into range of the Electronic SmartDoor; the green LED will stop blinking
and will illuminate continuously.The code has been successfully added to memory.
Learn Mode may be accessed when the Electronic SmartDoor is in any operating mode. Up to five
different SmartKey codes can be added to memory.When the Learn mode is activated, if no SmartKey
transmitter signal is detected, the green LED will blink for 60 seconds and extinguish; the Electronic
SmartDoor will return to its previous mode.
Error Mode
When the yellow LED is flashing, the Electronic SmartDoor is in Error mode, indicating an error has occurred.
If the flap is off-of-center, either to the inside or outside, while the flap is being pushed down to lock,
the Electronic SmartDoor will stop moving the flap down and start flashing the yellow LED.The
Electronic SmartDoor will remain in Error mode until the error is cleared. Simply center the flap, then
depress and hold the Mode/Reset button until the Electronic SmartDoor begins to lock.
Low Battery Indicator
When the red LED is flashing, the Electronic SmartDoor is in low battery condition.The four D-cell
batteries should be replaced as soon as possible to ensure the Electronic SmartDoor continues to operate
properly.
