Pixapro 70x100CM FLOOR SOFTBOX User manual

Box Content
The 70x100cm Floor Softbox contains four
rods (1x short, with a spigot, 1x medium,
and 2x long), the main softbox body, which
pops open like a reflector, and a round bag
for the softbox main body.
Step 1.
First, remove the winged-screw from Rod
S1 and then connect it to Rod S2 to form a
T-Shape
Step 2.
Now remove the winged screws from both
ends of the T-Shape, then attach an S3
rod at either the of the T-Shape to form an
H-Shape.
Step 4.
Now that the supporting frame is complete,
open out the main body of the floor softbox
then lift the top panel from the back ready to
install the supporting frame.
PIXAPRO 70x100CM FLOOR SOFTBOX
ASSEMBLY INSTRUCTIONS.
S1
S2
S3 S3
Floor Softbox
Main Body

ASSEMBLY INSTRUCTIONS
Step 5.
Use the four clips located at either end of
the supporting frame, to hold the main body
of the Floor Softbox open.
Step 6.
Now that the Floor Softbox is complete, all
that is left to do is mount your flash to the
spigot on the supporting frame, place the
flash head through the opening at the back,
and pull the drawstring to prevent light leak-
age
The Floor Softbox is Now Complete.
The PIXAPRO 70x100cm Floor Softbox is
now ready for use.
PIXAPRO LTD.
50 Popes Lane, Oldbury, West Midlands, B69 4PA
Tel: [phone]
Company Registration No. 07601334
Web: www.essentialphoto.co.uk
E-mail: [email protected]
Facebook: www.facebook.com/EssentialPhoto.UK
Twitter: www.twitter.com/EssentialPhoto_
®
www.essentialphoto.co.uk
70x100cm Floor Softbox
Assembly Video