PolyVision CeramicSteel User manual

polyvision.com
CeramicSteel Cleaning & Care
GV200306
Cleaning before First Use
1. If present, remove the protective film.
2. CLEAN:
Wipe board with a clean cloth (*) moistened with a mix of isopropyl alcohol and water (30/70 %v/v)
— the most effective whiteboard cleaner (**).
3. RINSE:
Rinse the surface with water and a clean cloth.
4. DRY:
Wipe surface dry with a clean cloth.
* For best results use microfiber cloth
** Using a non-appropriate cleaner may result in poor dry erase-ability due to the build-up of
residues from the cleaner on the surface.
General Cleaning & Maintenance
1. CLEAN:
Wipe board with a clean cloth (*) moistened with:
- Water: in most cases this will clean the surface just fine.
- Or a mix of isopropyl alcohol and water (30/70 %v/v) — the most effective whiteboard
cleaner (**).
2. RINSE:
Rinse the surface with water and a clean cloth.
3. DRY:
Wipe surface dry with a clean cloth.
* For best results use microfiber cloth
** Using a non-appropriate cleaner may result in poor dry erase-ability due to the build-up of
residues from the cleaner on the surface.
Cleaning frequency depends on the intensity with which the writing surface is being used. Daily or
at the very least weekly cleaning is recommended.

polyvision.com
Removing Markings & Residue
1. CLEAN:
Moisten a clean, dry cloth with water.
Apply a small amount of an abrasive cleanser to the cloth.
Note: For best results, follow the manufacturer’s instructions on the label.
Working in small sections, clean the area using a back-and-forth motion with gentle pressure.
2. RINSE:
Rinse well with clean water as soap residues on the surface will result in decreased dry erase-
ability.
3. DRY:
wipe dry with a clean cloth.
4. To quickly and easily remove permanent marker, write over the top of the writing with a dry-erase
marker. Then, simply erase. In most cases, this will remove the marker.
* For best results use microfiber cloth
** Using a non-appropriate cleaner may result in poor dry erase-ability due to the build-up of
residues from the cleaner on the surface.
Guido Vervaeren
Product Manager, Surfaces
O + 32 89 323130 Direct: [phone] M [phone] polyvision.com