POSIFLEX XT-2614E User manual

XT-2614E
Touch Terminal
User Manual
Package Contents
XT-2614E x1
User Manual x1
Power Adaptor 12V/50W x1
Power Cord x1
Views of XT-2614E
Front View Rear View
I/O Plate View
1
16750901010 Ver. Original
http://www.posiflex.com
1x Line Out
USB1~2 port COM1~2 (DB9) port
1x OTG USB 1x Micro SD slot
1 x RESET button
1x LAN port
1 x DC IN power connector

Hardware Installation
Installation and Configuration of XT-
2614E
During Installation and configuration of XT-2614E,
please do NOT power ON your monitor and
terminal.
Start to install XT-2614E according to the following steps.
1. Find the DC IN jack on the I/O plate. Upon
connecting the included power adaptor to
the jack, XT-2614E will power up after a
while.
2. After powering up for around 50~70
seconds, the operation screen is ready for
use.
3. On the rear left side of the main unit, there
are brightness adjustment push buttons.
Each single press continually on the + or –
brightness button changes the LCD panel
display brightness slightly.
4. On the lower left corner of task bar, press
Sound +/- buttons to increase/decrease
volumes, or scroll up/down the volume bar.
2

5. Similarly, on the middle part of task bar,
press to access Settings.
6. Next click Sound then Volume to scroll up
and down volumes control bar, then click
OK.
7. This series provides a software power on/off
command for application program
operations. If user would like to shut down
the system, please press the power button
on the left-sided control button area in the
rear panel.
8. For 3~5 seconds, a pop-window appears.
Click Power Off mode. Then press OK to
shut down the system.
9. Next time when restarting this series for
quicker restart, it can be configured to
choose a Quick Boot Mode by clicking
“The system will boot in Quick Boot
Mode next time” check box.
3

Routing Cables thru Passage from
Bottom for Gen 7E base
Start to route cables thru passage from bottom according to the following
steps.
1. Release the indicated base stand back cover
and base cover.
2. Release the compression lock of base stand
cover at both sides.
3. Pass all cables through the indicated cable
exit then cable passage for external
connection.
4. Close the base stand back cover and base
cover.
4

Side Mount Upgrade Kit Installation
1. Remove the 2 circled screws in the right
picture above remove the cover for side
mount upgrade kit.
2. Take out the cable inside this cover in the
right picture and connect the SL-104 cable
with the indicated one of the 2 prolonged
connectors inside the side mount upgrade
kit.
3. Gently arrange the excessive length of this
cable back in the hole and screw-fit it back
to the position originally occupied by the
cover. Please reserve the cover if there is
chance to have the side mount kit removed
in the future.
To get the detailed information on
※ XT-2614E, please check this model
from Posiflex Global Website (http://www.posiflex.com/en-
global/Download/download).
5