Precor Discovery Series User manual

Discovery™ Series Vertical Knee Up (702) Assembly Guide
To assemble your equipment, follow the steps in the order listed in this assembly guide. For more
product information, visit us at www.precor.com.
WARNING At least two people are required to assemble the equipment.
DO NOT attempt assembly by yoursel
f.
Assembly requirements
When assembling the equipment, we recommend you:
Unpack the box and assemble the equipment close to where you plan to use it.
Locate the equipment at least 79 inches (2 meters) away from walls or furniture on either side
of the equipment, and 79 inches (2 meters) away from objects behind or in front of the
equipment.
Assemble the unit on a solid, flat surface, so that it remains level and stable.
DO NOT move the equipment without assistance.
Required tools Specifications

Rubber mallet
Flat head screwdriver Equipment Dimensions:
26” L x 43” W x 65” H (670 mm L x 1100 mm W x 1660 mm H)
Equipment Weight:
201 lb (91 kg)
Hardware kit
Component Quantity
Component
Quantity
Hex head cap screw (M10 x 35) 12 Flat washer (13 x 26 mm) 8
Flat washer (11 x 23 mm) 12 Hex key (10 mm) 1
Socket head cap bolt (M12 x 35) 8
Begin assembly
Important DO NOT fully tighten the fasteners until instructed to do so.
To attach the crossbars to the upright frames (Figure 1):
1. While your assistant holds one upright stable, position the lower crossbar against it and attach it using
two bolts and two washers .
2. Attach the upper crossbar to the upright and attach it using two bolts and
two washers .
3. Position the other upright against the crossbars and attach the lower crossbar
two bolts and two washers .
4. Attach the upper crossbar using two bolts and two washers .
5. Fully tighten the fasteners.
Figure 1

Attach the pads
To attach the back pad:
1. Position the back pad against the frame on the upper crossbar and attach it using 4 bolts and 4 washers (Figure 2).
2. Fully tighten the bolts.
To attach the arm pads:
1. Position the arm pad with the low edge toward the middle.
2. Attach the pad using 4 bolts and 4 washers (Figure3). Fully tighten the bolts.
3. Repeat Steps 1 and 2 to attach the second arm pad.
Figure 2 Figure 3
Bolt the equipment to the floor
Precor recommends that the strength equipment be bolted down at all anchoring points. Bolting is made possible by removing the
end caps at the frame base and exposing the mounting holes that accommodate the bolts (see the accompanying figure). Replace
end caps when bolting is complete.
Important As floor materials vary, it is important that you consult a licensed contractor to advise you on proper bolting techniques and
appropriate fastener types.
Standards occasionally change or are updated. Precor recommends that you keep apprised of your local industry standards. Precor shall not
be held liable for failure to properly bolt the strength equipment to the floor.
Figure 4
DBR Vertical Knee Up (702) Assembly Guide | P/N CW39244-101 rev A, ENU
©2016 Precor Incorporated | August 2016