1a
Assemble the side panels: Starting with the left side
panel, slide the panel mesh (L3) into the left side frame
(L1), trapping the mesh between the pairs of “C” wires
on the frame legs. At the top of the mesh, wires extend
above the top of the panel. Align extended wires on
the mesh with holes on the underside of the frame.
2a
Assemble the front and back panels: The front
lower (F1) and back lower (B1) rails have holes
on the top surface, and tray channels on the inside
surface. The tray channels end flush on the left
end, and extend beyond the rail on the right end
(see detail).
Orient the front lower (F1) rail with holes facing up
and tray channel facing in. Secure with hex screws
through the side frame legs on both ends.
Instructions are the same for back lower (B1) rail.
2b
The front mesh (F2) panel has a door. The back
mesh (B2) panel is solid mesh. Both front and back
mesh panels have vertical wires extending above
and below the panel. The extended wires along the
bottom edge align with the holes on the top surface
of the front & back rails (F1 & B1).
Align the extended wires with the holes, and set
the front and back mesh panels into place.
1b
Finish by attaching the frame bar (L2). The left side
frame (L1) has stop-tabs (to stop the grille and tra from
pushing all the wa through), so the left sideframe bar
does NOT include the windbell lock. The top surface of the
frame bar has holes which align with extended wires on
mesh. Align wires with holes, and secure the frame bar
with hex screws through the frame legs on both ends.
Instructions are the same for the right side (R1-3).
st ps 2c
The front upper (F3) and back upper (B3) rails
have extended curved tabs on the top surface, and
extended flat tabs on the inside ends (see detail).
Along the bottom surface are holes which align with
the extended vertical wires on the panel mesh.
Orient the front upper (F3) rail with the opening on
the curved tabs facing in, and the end flat tabs also
on the inside. Align the holes on the underside with
the extended wires on the mesh. Secure rail with hex
screws through the side frame legs on both ends.
Instructions are the same for back upper (B3) rail.
3Insert the caster wheels: We suggest inserting the
two locking caster wheels on the front, where they
can be accessed easily when the cage is in use, but
all wheels will fit in all legs and locking casters can
be arranged to best suit your needs.
4Install the roof panel: At the back of the roof (C1)
panel, the first horizontal wire is extended on both
ends. These extended wires will align with holes on
the left and right side frames (L1 & R1).
Loosen the hex screws for the back upper (B3) rail
to allow some slack.
Hook the first horizontal wire of the roof (C1) panel
under the curved tabs on the upper rail, and insert
the extended end wires into the holes on the side
frames. Retighten the back upper rail hex screws.
Check and tighten all other hex screws, to create a
solid, stable cage.
L3
R3
L2
R2
B3
L1
R1
F3
B2
F2
B1
F1
