Prevue Pet Products 1307 Instruction sheet

Travel Carrier
Model: # 1307
Inst uctions online at www.p evuepet.com
read first REVIEW BEFORE ASSEMBLY
• No tools a e equi ed fo assembly
Fo assistance o eplacement pa ts,
please contact P evue Pet P oducts:
PHONE [phone]
ONLINE www.p evuepet.com
EMAIL custome se vice@p evuepet.com
1307—04/17— USL M de in Chin for Prevue Pet Products, Inc., 224 N M plewood Ave, Chic go IL 60612 USA • www.prevuepet.com • 1 [312] 243-3624 • customerservice @ prevuepet.com
1To assemble the CAGE BODY,
you will need these pieces:
2To add the ROOF and PERCH/
HANDLE, you will need these
pieces:
fig.1.1
fig.1.2
Touch the vertical frame rail surfaces together, aligning the knob on
the side panel with the hole on the back panel (fig.1.1) and the tab
extension on the side anel over the sleeve on the back anel (fig.1.2).
Slide the side anel down. The knob should lock into the hole
and the tab should slide into the sleeve.
Add on the side panel (with cup doors) and the front panel following
the same rocedure.
Set the roof into lace. Posts at the corners of the roof will insert
into the holes at the to corners of the front and back anels.
Set the perch/handle unit into lace, aligning the holes of the
bottom tabs with the holes on the front and back anels.
Screw the knobs into the aligned holes. This will secure the
handle to the carrier and lock the roof in lace.

1307—04/17— USL For more wonderful c ges, toys, nd ccessories for dogs, c ts, birds, chickens, r bbits, ferrets nd sm ll nim ls, visit www.prevuepet.com
3To add the COMPONENTS,
you will need these pieces: Unscrew the end-ca s from the erch ends.
Place the perch inside the carrier and oke the
notched screw- ost through to the carrier exterior,
catching a horizontal wire.
Screw the end-ca onto the screw- ost from
the exterior (fig.3.1). Tighten to a stable, snug fit.
Follow the same rocedure for the o osite end.
O en the cu door,
and insert the cup into
the cup holder, and
insert the osts of the
cu holder into the
sleeves on the inside
of the door (fig.3.2).
fig.3.2
fig.3.1
Rotate the windbell lock out
of the way and slide the grille
into the to track and the
tray into the bottom track.