Promeba CAMILLA User manual

01.1 Using this manual
This manual provides using and maintenance instructions
of the product, as well as the way of fixing minor
faults that could appear.
It is recommended before the operation of the product
to read carefully this manual in order to avoid damages
caused by a misuse.
Do not lose this document, it should be accessible to
any doubt that could appear by medical personnel.
Remember that a good use and maintenance are necessary
for the proper operation of the product.
Each product incorporates an identification sticker with
the serial number and the model.
Keep these numbers so that they can be indicated to the dealer if necessary.

680
800
740
330
880
300
MEASURES AND FEATURES
580
1920

800
680
740
330
880
300
MEASURES AND FEATURES
580
1920

02.1 Transporting and unpacking
First remove the packaging carefully to prevent
damage
to the exterior of the stretcher.
1.Transporting
· Always fi x the load, if piling up is necessary always
follow the scheme shown.
· Transport the leveled load and following all
precepts
and rules for the transport of loads.
2. Unpacking
· Place the box on a fl at, stable surface and open
the
seal being careful not to damage the inside.
· Remove the stretcher from the inside of the load as
shown in the scheme below.
Each stretcher has been minutely examined when
leaving
the factory. To ensure that it has not been
deteriorated
during transport, please carefully inspect the
outside and the inside, and in case of fi nding any
imperfection,
immediately contact the installer.
For an optimum operation, the stretcher must be
leveled.
UNIDAD DE EMBALAJE
RESPETE LA POSICIÓN DE TRANSPORTE
DEL EMBALAJE

03.1 Elements PC-650

Green, located on the stretcher left side.
The legs of the rear side will unlock by operating
the lever in order to place the stretcher in loading
and unloading position.
Red, located on the stretcher’s right side. The
legs of the front side will unlock by operating in
order to place the stretcher in loading and
unloading position.

· Open the loading ramp of the bench/rail (A)
· Place the stretcher head-on in relation to the loading axle of the bench (A)
· Approach the stretcher until the front wheels have contact with the loading ramp (B)
· Operate the right lever (RED) to unlock the front wheels (C)
· Decisively push to slide the stretcher into the ambulance (D)
· As the rear leg approaches, press the left lever (GREEN) to release the legs (E)
· Keep pushing until the stretcher is fully loaded (E)
· Pay attention to the third anchor point, you may heard a CLICK (in case of being installed)
· Close the loading ramp
· Open the loading ramp of the bench/rail
· Release the stretcher’s closure by operating the lever (in case of being installed)
· Pull the stretcher. It will slide outward, hold it with the hands
· Fold the loading ramp