Promeba PC-800 User manual

Chair Stretcher PC-800
Instructions Manual

1
I. Applicable scope
It is mainly used for hospitals, sports, ambulances and battlefields that carry injured people
and patients.
Ⅱ.Features
1. The bed surface of the stretcher is made of foam cushion, to prevent infiltration of the
blood produced. The back and the knee part are adjustable, which makes the wounded feel
comfortable.
2. There are three settings for different heights of the stretcher. Before opening the package,
please measure the height of the stretcher first. (According to the picture: 1 is 685mm, 2 is
670mm, 3 is 655mm)
Figure 1 Figure2
3. The stretcher has a safety lock that should be closed when transporting patients and
should be opened when boarding the ambulance.
4. The folding leg mechanism can be controlled on both sides of the handle.
5. Only one person can take the patient to the ambulance.
6. It is characterized by being light, safe to use and easy for sterilization
7. The use of round wheels, capable of adapting to the complexity of traffic.
Ⅲ. Technical parameters （Tolerance ± 5%)
Model
PC-800
High position（L×W×H）
190×58×84cm
Low position（L×W×H）
190×58×26cm
Maximum rear part angle
0~75°
Weight
32Kg
Load capacity
180Kg

2
Ⅳ. Method of use
1. Backrest angle adjustment: Hold the red handle at the end of a stretcher, and when you
need to restore the original look of the red handle, hold the red handle and under pressure.
The above action is completed with the gas spring
Figure 3
2. Safe transport: to lock the railings, when the barrier plate is in the vertical position, a
small noise will be heard shortly after the lock; the lift barrier lock will lock the blue stopped
according to the direction of the arrow button and the parapets below.
Figure 4
Warning: When blocking the stretcher barrier, pay attention to the parts of the body that
should not be caught.
3. Use of the safety belt: transport of the wounded person so that it is well closed, moderate
elastic
4. On the train: a small round of the compartment before the end of the ambulance (or
stretcher surface position), turn the red switch to the safe status level (vertical to lock,
unlock levels as shown in the Figure 6), hold forward to free the right hand (right hand
control for front brake handle stents), the stent will automatically go into the curve,
continue to advance, hold the left hand (hand control left for rear foot brake handle bracket).
The back supports the base of the ambulance, the back will automatically fold forward.
(Figure 5, Figure 7)
Warning: Make sure the red switch is in the unlocked state on the vehicle. When patients
are transferred to the level, the red switch should be locked.

3
Figura 5
Figura 6 figura 7
5. Fixed device: When you push the stretcher in the ambulance, the bar between the guide
wheel will be locked with two hooks of the device, and the rear bar will be locked with the
rear fixed device. (Figure 8)
Figure 8
Warning: Before using the fixed devices of the stretcher, make sure that the devices
become loose.

4
Figure 9
6. Lowering the stretcher from the vehicle: First unlock the stretcher, slowly pull it out of the
ambulance, bounce your rear foot forward to keep steady and continue to back off
automatically, ensure the red switch is locked and transfer the injured
IV. Stand adjustment
- Turn the black control knob to adjust the height of the stand.
- Hold the lower tube to control the elevation of the support or down. If the support is not
necessary, place the support and lock it on the stretcher. (Figure 10) Warning: when using
the I.V. bracket, please do not turn the control knob (Figure 11)
Figura 10 Figura 11
Ⅴ. Install fixed devices
There are two methods to install the F06 fixed device:
-Method 1: Install the device on the ambulance floor directly: use 6-piece M8 screw and
6-piece M8 nut, install the device on the base (Figure 12)
-Method 2: Install the device on the stretcher platform as method 1, then use a 6-piece M8
screw to install the platform on the floor of the ambulance. (Figure 13)

5
Figure 12 Method 1 (Install F06 installed on the ambulance floor directly)
Figure 13, Method 2 (Install F06 installed on the stretcher platform)
Ⅵ. Cautions
1. When transferring patients, be sure to lock the handrail and, if necessary, fasten the seat
belts.
2. When you wear the seat belts for some time, inspect regularly, if it is worn, loose the
screw, replace them immediately!
3. Surgery on the stretcher, do not lacerate the surface of the stretcher!
4. Do not turn the handle without raising or lowering the ambulance car.
Ⅶ. Maintenance
1. Keep clean as a routine (incl. Disinfect)
2. Check whether there are any loose parts or not as usual.

6
Ⅷ. Storage and transport
1. Store this stretcher in a non-humid and non-corrosive environment.
2. It can be transferred by common transports. 3. Reverse change during transportation and
storage is prohibited.
Ⅸ.Packing and accessories
1. Packed in high durability carton.