Promeba STRETCHER User manual

USER GUIDE
STRETCHER // PC-650
Revisión 02/20

3
USER GUIDE // STRETCHER PC-650
Revisión 02/20
01 INTRODUCTION
01.1 Uusing this manual 05
01.2 Technical data sheet 06
02 INSTALLATION
02.1 Transport and unpacking 09
03 OPERATING
03.1 Elements 10
03.2 Commands 13
03.3 Loading and unloading operation 14
03.4 Tensors 15
04 MOUNTING AND COMPONENTS
04.1 General view STRETCHER PC-650 17
04.2 Set strucure PC-650 20
04.3 Telescopic Hand Grips PC-650 22
04.4 Backrest regulator set PC-650 24
04.5 Backrest set PC-650 26
04.6 Lateral shift handrail set PC-650 28
04.7 Universal pole IV PC-650 30
04.8 Standard xed leg set PC-650 32
04.9 Standard revolving leg set PC-650 34
04.10 Inverted xed leg set PC-650 36
04.11 Inverted revolving standard leg set PC-650 38
05 GENERAL MAINTENANCE 40
06 LEGAL NOTICES 41
07 PRODUCT WARRANTY 42
08 TRAINING REGISTER 44
09 MAINTENANCE REGISTER 45
INDEX
MODEL PC-650
STANDARD CONFIGURATION
MODEL PC-650
INVERTED CONFIGURATION

5
USER GUIDE // STRETCHER PC-650
Revisión 02/20
01.1 Using this manual
This manual provides using and maintenance instruc-
tions of the product, as well as the way of xing minor
faults that could appear.
It is recommended before the operation of the product
to read carefully this manual in order to avoid damages
caused by a misuse.
Do not lose this document, it should be accessible to
any doubt that could appear by medical personnel. Re-
member that a good use and maintenance are neces-
sary for the proper operation of the product.
Each product incorporates an identication sticker
with the serial number and the model.
Keep these numbers so that they can be indicated to
the dealer if necessary.
01 INTRODUCTION

USER GUIDE // STRETCHER PC-650
Revisión 02/20
6
01 INTRODUCTION
01.2 Technical data sheet
MEASURES AND FEATURES // PC-650 - STANDARD
LENGTH 1920 mm INTERMEDIATE STOP 680-740 mm
WIDTH 580 mm FOLDED HEIGHT 330-300 mm
HEIGHT 800-880 mm MAX. LOAD 250Kg
WEIGHT 50 Kg
300
330
740
680
1920
580
880
800

7
USER GUIDE // STRETCHER PC-650
Revisión 02/20
MEASURES AND FEATURES // PC-650 - INVERTED
LENGTH 1920 mm INTERMEDIATE STOP 680-740 mm
WIDTH 580 mm FOLDED HEIGHT 330-300 mm
HEIGHT 800-880 mm MAX. LOAD 250 Kg
WEIGHT 50 Kg
01 INTRODUCTION
300
740
680
330
1920
580
880
800

9
USER GUIDE // STRETCHER PC-650
Revisión 02/20
02.1 Transporting and unpacking
First remove the packaging carefully to prevent dama-
ge to the exterior of the stretcher.
1. Transporting
· Always  x the load, if piling up is necessary always
follow the scheme shown.
· Transport the leveled load and following all precepts
and rules for the transport of loads.
2. Unpacking
· Place the box on a  at, stable surface and open the
seal being careful not to damage the inside.
· Remove the stretcher from the inside of the load as
shown in the scheme below.
Each stretcher has been minutely examined when lea-
vingthe factory. To ensure that it has not been dete-
riorated during transport, please carefully inspect the
outside and the inside, and in case of  nding any im-
perfection, immediately contact the installer.
For an optimum operation, the stretcher must be leve-
led.
02 INSTALATION
UNPACKING UNIT
RESPECT THE TRANSPORTING POSITION OF THE PACKAGE
PRODUCT UNPACKING
USE ALWAYS FLAT BASE AS SUPPORT

USER GUIDE // STRETCHER PC-650
Revisión 02/20
10
03.1 Elements PC-650
1. Handrail with lateral shift
2. Grips rings to elevate the legs in Trendelemburg position and Fowler.
3. Footrest
4. Rear leg operating lever
5. Front leg operating lever
6. Third anchor point
7. Rear wheels brake
8. Front revolving legs
9. Skate for a smoother load.
10. Stretcher’s guide protective disks
11. Front leg holding position operating lever
12. Telescopic hand grips
13. Universal pole IV
14. Backrest with adjustable inclination in 6 positions.
03 OPERATING
1
8
6
7
3
4
11
10
9
13
2
14
5
12

11
USER GUIDE // STRETCHER PC-650
Revisión 02/20
03.1 Elements PC-650
03 OPERATING
1
2 14

USER GUIDE // STRETCHER PC-650
Revisión 02/20
12
03 OPERATING
13
03.1 Elements PC-650
12
8 4

13
USER GUIDE // STRETCHER PC-650
Revisión 02/20
03.2 Commands PC-650
01. REAR LEGS UNLOCKING LEVER
Green, located on the stretcher left side.
The legs of the rear side will unlock by operating the lever
in order to place the stretcher in loading and unloading po-
sition.
02. FRONT LEGS UNLOCKING LEVER
Red, located on the stretcher’s right side. The legs of the
front side will unlock by operating in order to place the
stretcher in loading and unloading position.
03. HOLDING POSITION LEVER
Red, located on the front side of the stretcher. It allows a se-
cond position which facilities the loading of the patient.
03 OPERATION
01 02 03
01
02
03

USER GUIDE // STRETCHER PC-650
Revisión 02/20
14
03.3 Loading and unloading operation
LOADING
· Open the loading ramp of the bench/rail (A)
· Place the stretcher head-on in relation to the loading axle of the bench (A)
· Approach the stretcher until the front wheels have contact with the loading ramp (B)
· Operate the right lever (RED) to unlock the front wheels (C)
· Decisively push to slide the stretcher into the ambulance (D)
· As the rear leg approaches, press the left lever (GREEN) to release the legs (E)
· Keep pushing until the stretcher is fully loaded (E)
· Pay attention to the third anchor point, you may heard a CLICK (in case of being installed)
· Close the loading ramp
UNLOADING
· Open the loading ramp of the bench/rail
· Release the stretcher’s closure by operating the lever (in case of being installed)
· Pull the stretcher. It will slide outward, hold it with the hands
· Fold the loading ramp
A
03 OPERATION
B
C D
E F

15
USER GUIDE // STRETCHER PC-650
Revisión 02/20
03 OPERATION
03.4 Tensors
To adjust the tension in the drive cables, the stretcher has
three sets of tensors for its regulation:
1. REAR UNLOCKING LEVER
2. FRONT LEGS UNLOCKING LEVER
3. HOLDING POSITION LEVER
To regulate the tensioners, you have a clamping ange
where you can replace the tensioning cable (if it breaks) or
regulate its tension.
To adjust the tension of the cable has two locknuts (D).
Using a wrench 11 loosen the nut 2 and adjust the tension
of the cable using the nut 1. Tighten the nuts 1 and 2 again.
If the cable breaks, proceed to cut the cap, loosen the screws
(A-B) and remove the cable pulling from the handle terminal
(C).
1
2
3
1
2
3
A
B
C
D
2
1

17
USER GUIDE // STRETCHER PC-650
Revisión 02/20
04 MOUNTING AND COMPONENTS
04.1 General view STRETCHER PC-650
7880 79
5
40
10
30
39
3
38
31
4
13
7
36
14
6
25
17
15
28
18
26
12
1
34
42
23
16
2
8
32
11
27
20
22
41
29
24
9
10
09
STANDARD FIXED LEG SET
PAGE 32
GUIDE SET PC-650
PAGE 20
BACKREST REGULATION SET
PAGE 24
LATERAL SHIFT HANDRAIL SET
PAGE 28
UNIVERSAL POLE IV
PAGE 30
BUNK BED SET PC-650
PAGE 26
TELESCOPIC HAND GRIPS
PAGE 22
STANDARD REVOLVING LEG SET
PAGE 42
INVERTED REVOLVING LEG SET
PAGE 38
INVERTED FIXED LEG SET
PAGE 36
PC-650
INVERTED CONFIGURATION
SEE SETS ON PAGE 36

USER GUIDE // STRETCHER PC-650
Revisión 02/20
18
04 MOUNTING AND COMPONENTS
04.1 Bill of materials: GENERAL VIEW PC-650
ELEMENT NUM CODE - DESCRIPTION UNITS
1.1 PC6500-03182 - perl superior 2
1.2 PC6500-06000 - CONJUNT LLITERA PC-650 1
1.3 PC6170-03092 - Subconjunt travesser davanter 1
1.4 PC6500-03010 - Conjunt guia PC650 1
1.5 PC6170-03470 - Conjunt portasuero universal 1
1.6 PC6172-01000 - Conjunt pota giratoria estandar 1
1.7 PC6172-02000 - Conjunt pota xe estandar PC-617 1
1.8 PC6501-04000 - Conjunt baraneta desplaçament lateral 2
1.9 PC6500-03970 - conjunt maneta reforçada vermella 1
1.10 PC6500-06230 - Conjunt regulador respatller 1
1.11 PC6500-03460 - Subconjunt manetes extensibles 4
1.12 PC6500-03812 - Tope pota posterior 2
1.13 PC6500-03792 - LATERAL U SOPORT POTES DAVANTER 2
1.14 PC6500-03112 - laterals U soport potes 2
1.15 PC6500-03050 - brida patí 2
1.16 PC6500-03482 - tirant perls taula 1
1.17 PC6500-03232 - soport maneta dreta 1
1.18 PC6500-03242 - soport maneta esquerra 1
1.20 PC6500-03070 AMORTITZER 220MM-70N 1
1.22 PC6500-03080 AMORTITZER 320mm-70N 1
1.23 PC6500-03492 - GUIA TAULA 2
1.24 PC6500-03432 - SOPORT CABLE PATI 1
1.25 PC6100-03151 - TORRIO ENGANCHE 1
1.26 PC6100-03052 - TUB REPOSAPEUS 1
1.27 PC6170-03300 - maneta desplaçada dreta injecció 1
1.28 PC6170-03330 - maneta desplaçada esquerra injecció 1
1.29 PC6170-03422 - PATI DAVANTER DRETA SIMPLE 1
1.30 PC6170-03432 - PATI DAVANTER ESQUERRA SIMPLE 1
1.31 PC6170-03460 - tope lateral camilla 2
1.32 PC6170-03452 - TUB TOPE POTA DAVANTERA ALT 2
1.33 PC6500-03950 - FEMELLA SUBJECCIO PATI DAVANTER 2
1.34 PC6500-03960 - femella subjeccio manetes posteriors 2
1.35 PC6500-03120 - femella subjeccio elements 16
1.36 PC6170-01031 - Casquell potes 4
1.37 PC6500-03470 - casquell manetes extensibles 2
1.38 PB4010-00060 - Terminal funda cables T01-05 3
1.39 PC6170-03120 - Tub suport portasuero 2

19
USER GUIDE // STRETCHER PC-650
Revisión 02/20
04 MOUNTING AND COMPONENTS
04.1 Bill of materials: GENERAL VIEW PC-650
ELEMENT NUM CODE - DESCRIPTION UNITS
1.40 PC6170-03500 - Suport barana portasueros universal 1
1.41 CD-RUEDA-100 - roda 100x24 2
1.42 PC6500-06220 - biela regulació reposapeus 1
1.43 PC6500-03931 - Molla maneta 2
1.44 COMP00867 - Casquell rodes 12x30 2
1.78 PA6320-00000 - Conjunt matalas termosoldat Promeba 1
1.79 PC6500-04090 - Conjunt cinturons 10G Arnes superior 1
1.80 PC6500-04110 - Conjunt cinturons 10G Peus 1

USER GUIDE // STRETCHER PC-650
Revisión 02/20
20
04 MOUNTING AND COMPONENTS
04.2 Guide set PC-650
2 10
3
17
711
1
12
13
4
14
15
16
6
8 9
5