PUTCO 92009-60 User manual

92009-60 Supplement
PT — 11/15/18 Page 1 of 3 92009-60 Supplement
Supplementary Blade Wiring Instructions
2019 Silverado LTZ Package with LED Tail Lamps
Congratulations on your purchase of a high quality PUTCO product. Should you need any application
or technical assistance, feel free to call us at: 1-800-247-3974
Monday-Friday 8:00 a.m. - 5:00 p.m. (Central Standard Time)
Additional Tools Needed:
− T15 Torx Driver
− Wire Crimpers
− Zip-Ties
Installation Instructions
1. Remove tail gate to make mounting Blade easier
2. Light bar brackets need to be 1/4” to 5/16” above metal “ridge”
to allow enough clearance between tail gate and lightbar
• Use light bar bracket to achieve proper gap between
ridge and light bar (Figure 1).
Blade lightbar Bracket
“Ridge”
Figure 1. Locating light bar with bracket
1/4” to 5/16”
gap

92009-60 Supplement
PT — 11/15/18 Page 2 of 3 92009-60 Supplement
3. Remove tail lights by removing (2) T15 torx screws inside bed. Pull tail lamps straight out to release
clips. Disconnect wiring harness by pushing red lever away from light housing and then depressing
black clip. Twist out halogen back-up bulbs
4. Cut 4 pin trailer plug off of Blade light bar, making the cut close to the plug. Route yellow, brown,
black, and white wires to driver’s side tail lamp. Do not cut the red wire coming from the Blade logic
box.
5. Route the green wire from the Blade logic box to passenger side tail lamp.
6. Connect the following wires wire crimpers and the provided Scotchlock splices:
Figure 3: Reverse wire hooked to halogen back-
up bulb plug
Function Truck Wire Color Blade Wire Color
Left Turn Signal Green wire on driver’s side plug (Figure 2)Yellow
Right Turn Signal Green wire on passenger’s side plug Green
Running Lights Brown wire on driver’s side plug Brown
Ground Black wire on driver’s side plug Black
Reverse Light green wire on halogen bulb plug (Figure 3)White
Figure 2: LED tail light plug

92009-60 Supplement
PT — 11/15/18 Page 3 of 3 92009-60 Supplement
7. Test functionality of Blade before securing wires with zip-ties, reinstalling tail lights, and reinstalling
tail gate.
• Double-check Scotchlock connections if Blade is only partially functional (i.e. right turn sig-
nal does not function, but all other functions are present).
8. Ensure that Blade LED lightbar does not interfere with tail gate operation. If the tailgate does hit the
lightbar while opening, check that lightbar placement from step 2. Relocate the lightbar slightly low-
er if necessary.
Thanks and enjoy
your new Putco
product!