Raven AccuBoom User manual

Case IH SPX3310
CAN AccuBoom
Installation Manual
Manual No. 016-0171-005 Rev. C 12/16 E28917
Copyright 2016

While every effort has been made to ensure the accuracy of this document,
Raven Industries assumes no responsibility for omissions and errors. Nor is any
liability assumed for damages resulting from the use of information contained
herein.
Raven Industries shall not be responsible or liable for incidental or consequential
damages or a loss of anticipated benefits or profits, work stoppage or loss, or
impairment of data arising out of the use, or inability to use, this system or any of
its components. Raven Industries shall not be held responsible for any
modifications or repairs made outside our facilities, nor damages resulting from
inadequate maintenance of this system.
As with all wireless and satellite signals, several factors may affect the availability
and accuracy of wireless and satellite navigation and correction services (e.g.
GPS, GNSS, SBAS, etc.). Therefore, Raven Industries cannot guarantee the
accuracy, integrity, continuity, or availability of these services and cannot
guarantee the ability to use Raven systems, or products used as components of
systems, which rely upon the reception of these signals or availability of these
services. Raven Industries accepts no responsibility for the use of any of these
signals or services for other than the stated purpose.
Disclaimer

Table of Contents
Manual No. 016-0171-005 Rev. C i
Chapter 1 Introduction............................................................................................................. 1
Instructions for Hose Routing ....................................................................................................2
Chapter 2 Cable Installation.................................................................................................... 5
Components Needed ................................................................................................................5
AccuBoom Installation ...............................................................................................................5
Chapter 3 System Troubleshooting ...................................................................................... 9

Table of Contents
ii Case IH SPX3310 CAN AccuBoom Installation Manual

CHAPTER
1
Manual No. 016-0171-005 Rev. C 1
CHAPTER1 INTRODUCTION
The AccuBoom system is designed to provided worry free turn-on and turn-off of your booms with respect to the
as-applied coverage map. The following instructions are designed to assist you in the proper installation of the
AccuBoom system. Refer to the Viper Installation and Operators Manual for instructions on setting up the software
and using the AccuBoom system. You will also need a valid AccuBoom Control Activation Key for your Viper
system in order to activate the AccuBoom system. Instructions for Wire Routing
The word “harness” is used to mean all electrical leads and cables, bundled and unbundled. When installing
harness, secure it at least every 30 cm (12in) to the frame. Follow existing harness as much as possible and use
these guidelines:
Harness should not contact or be attached to:
• Lines and hoses with high vibration forces or pressure spikes
• Lines and hoses carrying hot fluids beyond harness component specifications
Avoid contact with any sharp edge or abrading surfaces such as, but not limited to:
• Sheared or flame cut edges
• Edges of machined surfaces
• Fastener threads or cap screw heads
• Ends of adjustable hose clamps
• Wire exiting conduit without protection, either ends or side of conduit
• Hose and tube fittings
Routing should not allow harnesses to:
•Hang below the unit
• Have the potential to become damaged due to exposure to the exterior environment. (i.e. tree limbs, debris,
attachments)
• Be placed in areas of or in contact with machine components which develop temperatures higher than the
temperature rating of harness components
• Wiring should be protected or shielded if it needs to route near hot temperatures beyond harness component
specifications
Harnessing should not have sharp bends
Allow sufficient clearance from machine component operational zones such as:
• Drive shafts, universal joints and hitches (i.e. 3-point hitch)
• Pulleys, gears, sprockets
• Deflection and backlash of belts and chains
• Adjustment zones of adjustable brackets
• Changes of position in steering and suspension systems