Raymarine ST40 User manual

Distributed by
Any reference to Raytheon or
RTN in this manual should be
interpreted as Raymarine.
The names Raytheon and RTN
are owned by the
Raytheon Company.

Adjusting display backlighting/contrast
Normal operation
ST40 Bidata Instrument - quick reference guide
orTo exit adjust mode press or wait for 5 second timeout
LEVEL 1 LEVEL 1 OFF LEVEL 2LEVEL 3LEVEL 2
To enter adjust mode, press for 1 second to adjust BACKLIGHTING and a further 1 second to adjust CONTRAST
SWITCH ON
Last permanent
screen is displayed
SPEED DEPTH
Current
speed
3 seconds
Reset
Maximum
speed
3 seconds
Reset
Average
speed
Water
Temp.
Log
Trip 3 seconds
Reset
Depth
Minimum
depth
Shallow
alarm
Deep
alarm
Deep
anchor
alarm
Offset
Shallow
anchor
alarm
3 seconds
Alarm on/off
3 seconds
Alarm on/off
Set
alarm
level
3 seconds
Alarm on/off
3 seconds
Alarm on/off
+
-
Notes:
*denotes temporary screens
which will time-out to the previous
permanent screen after 5 seconds.
On repeater instruments, only the
Speed, Water temperature,
Depth and Minimum depth
screens are available.
With Set alarm level screen displayed,
to save the alarm level and return to
normal operation.
and keys simultaneously
press the
86048_2.p65 18/04/01, 16:351

Calibration
ST40 Bidata Instrument - quick reference guide
Document number: 86048_2 (to be used with handbook: 81159_2)
Date: 1 May 2001
Press for 3 seconds
to apply SOG as
current speed
USER CALIBRATION
for 2 secondsHold down and
Temp.
units
Set to
SOG
Depth
response
Speed
units
Speed
response
Depth
units
Cal
factor
INTERMEDIATE
CALIBRATION
Software
version
Depth
status
Hold down
and
for 4 seconds
Speed
status
Depth
offset
Shallow
alarm
lock
W/L
OFST
KEEL
WARNING:
Correct offset values
are essential to the safe
operation of the vessel.
MASTER
REPEATER
C
FA
M
To leave any calibration routine
and return to normal operation,
hold down
for 2 seconds
+
-
+
-
+
-
and
FT
KPH
MPH
KTS
F
OFF
ON
Distance
units
SM
KM
NM
MASTER
REPEATER
User
cal If there is no key activity with either
the User cal or Software version
screen displayed, calibration will time
out to normal operation after 5 seconds
86048_2.p65 18/04/01, 16:352