Raymarine ST60 Tridata User manual

Race start timer 1
Race start timer 2
to enter Adjust mode.
to set timer value.
To adjust a timer, simultaneously press
AND
OR
To leave Adjust mode, simultaneously press
AND
Water
temperature
In Adjust mode, use
1s to Reset
1s to Reset
1s to Reset
1s to Reset
2s to Reset
2s to Reset
Count-up
timer
ST60 Setup & Operation Cue Card
Introduction
This cue card provides a quick reference guide to the operation and calibration features of
the ST290 Tridata instrument. Unless stated otherwise, all key presses are momentary.
Current
depth
Shallow alarm
threshold
Deep alarm
threshold
Anchor shallow
alarm threshold
Anchor deep
alarm threshold
VMG to
windward
Average speed
Maximum
speed
Boat speed Log
Trip
Operation
86037_3.fm Page 1 Tuesday, November 19, 2002 7:55 AM

Document number 86037_3 (to be used with handbook: 81040_4)
Date: 1st December 2002
ST60 Setup & Operation Cue Card
Illumination
Enter Illumination Mode
Alarms
Hold down for 1 second
Press repeatedly to cycle through settings
Hold down for 2 seconds
Momentary while alarm value is displayed
Increase value Decrease value
Switch On/Off
Enter & Exit Adjust Mode
Adjust
Calibration
User Calibration
Depth
Speed
Intermediate Calibration Dealer Calibration
Depth Units
Depth Offset
Shallow Alarm Lock
Speed Units
Speed Resolution
Log Units
Speed Calibration
(SOG or manual)
Temperature Units
Temperature Calibration
Time Beep (On/Off)
Software Version
Master/Repeater Selection
(manual setting)
Speed Calibration (auto)
User Calibration (On/Off)
Speed Response (Fast/Slow)
Depth Response (Fast/Slow)
Boatshow Mode (On/Off)
Factory Defaults (On/Off)
User Calibration Mode Intermediate Calibration Mode Dealer Calibration Mode
Exit Calibration Mode & Save Changes
12 seconds
then
2 seconds 4 seconds
2 seconds
86037_3.fm Page 2 Tuesday, November 19, 2002 7:55 AM