Rimage DLN5200 Operating and safety instructions

110769_H
1
Rimage DLN5200™Setup and Installation
Before you begin:
This document is intended for people who are familiar with hardware setup, software installation, and Windows operating systems.
If you do not understand the procedures in this document, ask your computer technician for help.
Set up your DLN5200.
1
Tape
Tape
Tape
Tape
Tape
a. Remove the tape
from the front cover.
b. Remove the front
cover.
c. Remove the tape from
the transfer slides inside
the autoloader.
d. Remove the tape
from the supply bin.
e. Remove the tape
from the printer
mounting plate.

110769_H
2
Set up your printer.
2
a. Unpack the Everest printer. b. Place the printer on the
DLN5200 so that the
plastic feet slide into the
slots on the printer plate.
Printer plate
Slots for feet
Connect the printer cables.
3
a. Connect the short
power cord from
the DLN5200 to
the printer.
b. Connect the USB cable
from the autoloader to
the printer.
c. Connect the D-shaped cable from the
autoloader to the printer as indicated by the
D-shaped label.

110769_H
3
Connect the cables.
4
a. Be sure that the power switch is in the off
position.
b. Connect the power cord from the DLN5200 to
a power outlet.
Install the front cover.
65
c. Connect the network cable to
the embedded PC.
Important! Do not power on the DLN5200
until you are instructed to do so.
Connect a monitor, mouse, and keyboard (optional).

a. Connect the mouse
to the embedded PC.
b. Connect the
keyboard to the
embedded PC.
c. Connect the monitor
to the embedded PC.
Keyboard
Mouse
Monitor

110769_H
4
Congure the DLN5200.
Power on the DLN5200.
7
Learn more.
10
For information about submitting orders to the DLN5200
across a network, refer to the Advanced Setup (Network)
Guide.
For information about operating and maintaining the
DLN5200, refer to the DLN5200 User Guide included with
your product.
For additional support and product information, go to
www.rimage.com/support.html.
If you will submit jobs from other networked PCs, refer
to the Advanced Setup (Network) Guide.
If you connected a monitor, keyboard, and mouse, log into
the Rimage DLN5200 with the following username and
password:
Username: Adminstrator
Password: password
8
Activate your Rimage Software.
You have 30 days to activate your Rimage software.
Until your software is activated, you will be prompted to
activate your software each time you use the Rimage
software.
When the activation dialog displays, select an option and
follow the onscreen prompts to activate your software.
9
a. Set the switches to
the on position.
Note:The main power switch is used to apply power
to the entire system, while the PC power switch
applies power to the embedded PC. For more
details, refer to your user guide.
b. Press the PC power button to power on the system.
PC Power Switch
Main Power Switch
PC Power Button
Important! Rimage recomends that your Network
Administrator use these instructions as a guide to
complete the conguration and software installation.

