Rimage Producer III User manual

1 2000538_C
Producer™ III and IIIN
Maintain the Producer III
Use the information in this section to keep your Producer III in optimal operating condition.
Overview
Regular preventative maintenance of your Producer III can help to ensure error-free recordings and clean printed labels.
Maintenance involves cleaning the system and aligning the printer on top of the autoloader.
Note:
The printer has its own maintenance requirements. Refer to your Printer User Guide for information.
Cautionary Information
Caution:nTo avoid damaging the Producer III during maintenance:
Never use oils, silicone, or other lubricants on any part of the Producer III
• .
Use only non-abrasive cleaners to wipe down the surfaces of your Producer III
• .
Never use cleaners to clean the embedded PC.•
Avoid pouring cleaners directly onto the Producer III. Instead, apply the cleaner to the cloth rst.•
Observe precautions for electrostatic-sensitive devices whenever you access the embedded PC• .
English

22000538_C
Maintain the Producer™ III
Preventative Maintenance Schedule
Note:Your system may require more frequent maintenance if used in a dusty area, such as a store or warehouse.
Before you begin:
Warning!
,Always power off the autoloader and unplug the power cord before you access the embedded PC.
Power off the
1. Producer III.
Disconnect the
2. power cord.
Important!
- Failure to follow the maintenance schedule outlined below may void your warranty.
Task Tool Frequency
Wipe down the lift arm shaft and pay
close attention to:
The area around the base of the
•
shaft
The area just above the lift arm
•
Lint-free cloth Weekly
Wipe down all surfaces of the
autoloader, including:
Sides and top
•
Door•
Output bin•
Carousel•
Base (remove the carousel rst)•
Top surface on the lift arm•
Lint-free cloth
Non-abrasive, all-purpose cleaner
Weekly
Remove dust and debris from the fans
at the back of the autoloader.
Can of compressed air Monthly
Remove dust and debris from the
openings at the back of the autoloader.
For embedded systems only (6100N,
7100N, and 8100N), remove the
carousel and remove dust and debris
from the openings to the PC module.
Vacuum Monthly
Align the printer. Refer to the Align the
Printer instructions in your User Guide.
Torx T25 screwdriver Upon installation, if the discs are not
picked correctly from the printer tray, or
if there are clamping errors.
English