ȱ
ȱ
Page iv
CHAPTER 3 INSTALLER PROGRAMMINGϯϯ
PROGRAMMING METHODSϯϯ
Allocating the Installer’s LCD Keypad & Defining the System Languageϯϯ
Allocating the Customer’s LCD Keypad & Setting the Default Languageϯϰ
Configuration Softwareϯϱ
Storing and Transferring System Configuration Data via PTMϯϱ
WIRELESS DEVICE ALLOCATIONϯϳ
Quick Allocation of all Devices at the Main Panelϯϳ
Table of Device Transmissionsϯϴ
Device Allocation using the Wireless LCD Keypadϯϵ
RF Allocation Methodϯϵ
Serial Number Methodϯϵ
Zone Allocation MethodϰϬ
Allocating Devices using the Configuration SoftwareϰϬ
DELETING DEVICES ϰϭ
Deleting all Devices Simultaneously from the LCD Keypadϰϭ
Deleting a Single Device from the LCD KeypadϰϮ
Deleting all Devices Simultaneously from the Configuration SoftwareϰϮ
Deleting a Single Device from the Configuration SoftwareϰϮ
ESTABLISHING COMMUNICATION TO THE RISCO CLOUDϰϯ
Step 1: Enabling Cloud Communicationϰϯ
Step 2: Defining the (GPRS or IP) Communication Channelϰϯ
Connecting with GPRSϰϯ
Connecting with IPϰϯ
Step 3: Defining Cloud Parameters for IP or GSM/GPRSϰϯ
Step 4: Registering to the RISCO Cloudϰϰ
IRISCO APP ϰϰ
PIR CAMERA SETUPϰϱ
CHAPTER 4 INSTALLER MENUSϰϲ
DESCRIBING THE WIRELESS LCD KEYPADϰϲ
ACCESSING THE INSTALLER MENUSϰϲ
PROGRAMMING MENUϰϳ
1. System Sub-Menuϰϳ
1.1 Timers ϰϴ
1.2 Controls ϱϬ
1.3 Labels ϲϬ
1.4 Sounds ϲϭ
1.5 System SettingsϲϮ
1.6 Service InformationϲϮ
1.7 Firmware Updateϲϯ
1.8 Picture Serverϲϯ
2. Programming: Radio Devices Menuϲϰ
2.1 Allocation ϲϰ
2.2 Modificationϲϱ
2.2.1 Zones ϲϱ
2.2.2 Remote ControlsϴϬ
2.2.3 KeypadsϴϮ