Rize I-PK170 User manual

1 2
All frames include:
(2) Side Rails with Cross Rails
(2) Extender Rails
(2) End Caps
(2) Screws (4 Screws for I-CS frames)
(2) Thumb Nuts (4 Thumb Nuts for I-CS frames)
(1) Center Rail (I-CS frames include a Double Center Rail)
I-PK & I-CS Bed Frame Assembly Instructions
Use with models: I-PK170, I-PK165, I-PK465, I-PK470; I-CS374PR, I-CS374PG
Foot parts for I-PK165, I-PK465, and I-CS374PG:
(6) Glides
Foot parts for I-PK170, I-PK470, and I-CS374PR:
(4) Plastic Sockets
(4) Rollers
(2) Glides
Parts included:
3
3
Find the keyholes on the cross rails needed for the appropriate size bed. See images below.
Set side rails out with the headboard brackets
on the same end. Swing out cross rails from
the side rails to a 90° angle.
Install the glides OR the sockets & rollers on
the legs.
Plastic
Glide
Roller
◄
◄
◄
Socket
For Queen Size Beds For California King Size Beds
For King Size Beds
Insert rivets on extender rail into selected keyholes. Slide arms away from each other to lock the position. Then insert
plug lock into keyhole at the end of the overlap. Repeat on the other side of the bed.
Plug Lock

www.rizebeds.com | 1-844-545-8865 | [e-mail]
Copyright Rize 12/5/2019
4
Slip the end caps over the foot ends of the side
rails (opposite the headboard brackets). Your
bed frame is now ready to use.
6
Attach each end of center rail to the extender rails using screws and thumb nuts. First, select the correct holes on the
extender rails, which will be determined by your frame model. For I-PK frames, use just the center hole. I-CS frames
use the first and third hole (not the center hole).
5For I-PK model frames: Insert a screw through
the hole in the center rail and the middle hole
in the side extender rail. Center rail should run
head to foot. Secure with thumb nut. Repeat
at the other end. Center rail can be used for
all sizes.
Use for I-PK
Use Ends for I-CS
I-CS model frames have a double center rail.
Insert a screw through the holes at the ends
of the center rail and the two end holes in the
side extender rail. Center rail should run head
to foot. Secure with thumb nut. Repeat on
the other end.