Roca 9505388 User manual

IN-TANK
5 min
When WC has been unplugged for a long time or for the first use allow 5 minutes before operation.
2 flush volumes:
·Full flush
·Reduced flush
Option to install buttons on left or right
3L 4.5L
ON
Reduced Full
Before any maintenance operation, shut off the toilet
power supply line.
OFF

2
Flush volume adjustment
Tank capacity
The water tank has 9 litres capacity, it allows the toilet to flush 3 times
with 3L or 2 times with 4.5L if the water supply fails.
9L
Light signal
After 1 or more flushes, the light flashes softly to
indicate that the water tank is filling.
3L
Decrease
aprox. 0.5L
Increase
aprox. 0.5L
4.5L
- In case of power supply failure, the toilet remains
operative for a number of flushes (see table).
- When there is not enough power in the toilet, the
light flashes at a high frequency.
Power supply failure
3L
4.5L
1 2 3 4 5 6 7 8 9 10 11 12

3
In case of long periods without use
1
1
2
3
4
2 3 4
OFF
When not using for a long period (especially in cold places to avoid the risk of freezing of the water in the
tank, which could damage the toilet):
Remove rear cover
Close the stop valve
Flush until no water flushes
Shut off power supply line
It is not recommended to install in places
out of this range
Range of inlet pressure
50 kPa (0,5 bar) ~1000 kPa (10 bar)
It is not recommended to install in places
out of this range
Temperature usage range
5ºC 45ºC
P

A392501290b
1
1
2
2
1 2
3 4
5
Before replacing the mechanism, shut off the
toilet power supply line.
OFF
Maintenance
[e-mail]
[e-mail]
Roca Sanitario, S.A.
Avda. Diagonal, 513
08029 Barcelona
SPAIN
www.roca.com