Ropeflex RX505 User manual

PLEASE REGISTER YOUR NEW PRODUCT
To register your product online please go to:
www.hipeq.com/product-registration
Product serial number is located on equipment or is shown in the box below
SERIAL NUMBER
If serial number is not shown
please check equipment
RX505 ADJUSTABLE RAIL SYSTEM
Product Manual
DOC: 32-RX505RAIL
Configuration subject to change

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
1
WARNING: To reduce the risk of serious injury, read the following important precautions before
using this equipment.
1. Read all instructions in this manual and
assemble as described before using this
equipment.
2. It is the responsibility of the owner to ensure
that all users of this equipment are
adequately informed of all precautions.
3. Use this equipment only on a level surface.
Cover the floor beneath to protect the
surface.
4. Keep children under 12 and pets away from
the equipment at all times.
5. Make sure all parts are properly tightened
each time you use this machine. Replace
any worn parts immediately.
6. Make sure the adjustment knobs are fully
engaged / disengaged before using the
equipment.
7. Always wear athletic shoes for foot
protection while exercising.
8. This equipment is designed to support a
maximum user weight of 300 pounds.
9. Pull on one the rope only and never grab a
rope in a way that prevents the drum from
rotating. Never attempt to hang on the rope
or frame. Pull rope with hands only.
10. If you feel pain or dizziness at any time
while exercising, stop immediately and
begin cooling down.
WARNING: Before beginning this or any exercise program, consult your physician. This is
especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. HiPEQ assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
2
With an optional rail installation kit adjustable rail can be installed on most types of walls, studs,
upright beams, concrete, brick and cinder blocks. Fasteners for each installation can be
purchased at your local hardware store or online.

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
3
¾” and ½” Hex Socket Ratchet Wrench
¾” Hex Socket Ratchet Wrench
𝟑𝟖
⁄ " Hex L-Key
¼” and 𝟗𝟏𝟔 ⁄ " Pilot-hole Drill Bits for Wood Lag Screws
WARNING: Use certified professional installation services or consult with an
installer. ROPEFLEX can also connect you with an independent trained
installer.
FASTENERS: Use ½ -13” size fasteners (not supplied) for concrete, brick or cinder block
installations.

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
4
QUANTITY
DESCRIPTION
1
Upright Rail with plastic end-caps
1
RX505 Endless Rope drum with rope
1
RX505-RA Rail adapter with pull pin
2
Wall extension
2
½ - 13” x 1” long socket screw
2
½ - 13” x 6” long bolt
2
½” fender (oversized) washer
2
½” standard size washer
2
½” x 2.5” long wood screw
Wall extension kit shown

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
5
Through hole door or panel installation
PLASTIC END-CAP
HEX KEY ACCESS
TIGHTEN SCREW

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
6
Through hole post installation (4x4”, 6x6” or similar)
HEX KEY ACCESS
TIGHTEN SCREW

R X 5 0 5 W I T H U P R I G H T B R A C K E T 32- R X 5 0 5 R A I L R E V . A
7
Stud front (face) installation (2x4”, 2x6” or similar including concrete, cinder or brick block with
required hardware)
HEX KEY ACCESS
TIGHTEN SCREW

8
If you have any questions regarding HiPEQ
equipment or any instruction found in this document,
please call 650.549.5888 for assistance.