ROSE DISPLAYS GOTCHA WITH LOOP TO LOOP User manual

The Gotcha®is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #00INSGO
Parts
35 Congress Street, Salem MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Instructions For Hanging
Instruction Sheet
Step 1
Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1
Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder.
Step 2
Thread loop through V-clip. Fig. 2
Step 3
Thread the other loop through the One Up
Gotcha Clip. Insert the One Up Gotcha Clip
into the backside of the Gotcha. You should hear
a “SNAP” when the clips are inserted properly.
If you are hanging a one-up application you will
use only one clip. Fig. 3
Step 4
Squeeze the V-clip onto the ceiling grid
to suspend poster.
Important note:
Please save and reuse the Gotcha Holder, V Clip,
Loop to Loop Cable and the OneUp Gotcha
Clips for future projects.
OneUp Gotcha Clip
1UP-5066 Loop to Loop
Cables V Clip
25-0394
Gotcha
®
Gotcha
12G100
Incept-7.16.01
Figure 1
Figure 2
Figure 3