ROSE DISPLAYS ECONOFRAME WITH CABLE CLIP AND BALL CHAIN User manual

Parts
Instruction Sheet
Step 1
Insert corner brackets into split rails and
into rail opposite split
rail. Split rail side is made up of
two separate pieces. Fig. 1
Note: Corner bracket tension tabs must
face toward inside
of frame.
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 3
Step 3
Align one round end of cable clip with top
channel of the rail and insert. Once in
place, insert end of ball chain into chan-
nel. Then press down on the other round
end of the cable clip and slide into rail by
pushing on the clip. Fig. 4 Repeat steps 2
& 3 for second CableClip.
Note: Be sure to push on the cable clip
in order to slide the ball chain into place.
Do not pull on, or push against, the ball
chain as this will cause it to bind in the
channel.
Step 4
Assemble frame following steps in. Fig. 4
sliding sides together in the order shown.
Step 5
Insert poster. Fig 5.
Instructions for Hanging
Incept-11.13.02
The EconoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSEconoFrameCCBallChain
Corner
brackets
EconoFrame
TM
Figure 1
Figure 2 Figure 3
solid rail w/
solid rail
split rails
34
Figure 4 Figure 5
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
split rails
solid rail
2
1
EconoFrame rails
12EF-100
EconoFrame
split rails
Cable Clips
06-5050
Ball Chains
96-0302P

Parts
Instruction Sheet
Incept-11.13.02
The EconoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSEconoFrameCCBallChain
EconoFrame
TM
Figure 1
Figure 3
solid rail w/
solid rail
split rails
34
Figure 4 Figure 5
Figure 2
split rails
solid rail
2
1
Corner
brackets
EconoFrame rails
12EF-100
EconoFrame
split rails
Cable Clips
06-5050
Ball Chains
96-0302P
Step 1
Insert corner brackets into split rails and
into rail opposite split
rail. Split rail side is made up of
two separate pieces. Fig. 1
Note: Corner bracket tension tabs must
face toward inside
of frame.
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 3
Step 3
Align one round end of cable clip with
top channel of the rail and insert. Once
in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into
rail by pushing on the clip. Fig. 4 Repeat
steps 2 & 3 for second CableClip.
Note: Be sure to push on the cable clip
in order to slide the ball chain into
place. Do not pull on, or push against,
the ball chain as this will cause it to
bind in the channel.
Step 4
Assemble frame following steps in. Fig. 4
sliding sides together in the order shown.
Step 5
Insert poster. Fig 5.
Instructions for Hanging