Roverpet KK-CPC-3 User manual

Roverpet 20 Kiji Dava Circle Prescott, Arizona 86301 800-658-5925 [e-mail]
Roverpet #KK-CPC-3 Play Center Assembly Instructions
Note: the #CPC-3 Roverpet Cat Play Center is designed and sold as an add-on accessory
for the #KK3 Cat Climber. The fabric enclosure of the #CPC Cat Play Center installs in
place of the two standard sheepskin pads that are normally installed on the two-level
tower of the #KK3 assembly. The frame tubing shown in the photo above is presented for
instruction purposes only, and is not included with the #CPC Cat Play Center.
Inventory: one fabric cat play center
1.) Unpack the Roverpet #KK3 Cat Play Center you with be installing this
accessory on and check the contents against the inventory list included
with the product.
2.) Disregard the steps pertaining to the 2-level tower assembly in the #KK3
instructions. Instead, complete the assembly of the 2-level tower assembly
with these instructions and then refer back to the #KK3 instructions to
assemble the 3-level tower and complete the assembly.
3.) Connect the two #24TLC legs together by inserting two #17 CBC
crossbars into the holes between them as seen in the photo below.

Roverpet 20 Kiji Dava Circle Prescott, Arizona 86301 800-658-5925 [e-mail]
4.) Insert the four #34URP uprights into the upward facing holes of the
#24TLC legs in the following manner: the two pipes identified with red
marks on their tops are to go into the lower left and upper right locations
as viewed with one of the long faces of the assembly positioned in front of
you. Turn the upper-most holes in the uprights to face each other across
the longer faces of the assembly as shown in the left photo at the top of
the next page.
5.) Install the corner rings of the fabric cat play center over the uprights, being
sure that the sheepskin fabric is facing up as shown in the above right
photo.
6.) Install the short and long cross bars into the holes in the uprights to mimic
the assembled view that appears in the photo at the top of the previous
page while paying attention that the following assembly criteria are
adhered to:
The bottom rings of the enclosure must rest under the first (lowest)
set of long cross bars that span across the wider faces of the tower
The upper set of short bars that spans across the narrower faces of
the tower are to pass through the support sleeves in the fabric
enclosure.
The top rings of the cat play center must rest on top of the highest
cross bars that span across the wider faces of the tower.
7.) Install the top arms into the open ends of the uprights.
8.) Refer to the instructions included with the Roverpet #KK3 Cat Climber to
assemble the 3-level tower and to complete the unit. To reduce the
squeaking/friction caused by product on product place a thin layer of Vaseline on
the connection points.
Property of Roverpet
WWW.ROVERPET.COM
Install the uprights with
red marks on their tops at
these two locations and
face the upper-most holes
in the uprights towards
each other across the
longer faces of the
assembly as shown by
the green arrows.