Sanipex AQUAECO AQE-ECO-251-XX User manual

AQUAECO
WASHROOM AND PLUMBING SOLUTIONS
AQE-ECO-251-XX
AQUAECO ROUND WALL TOUCHLESS SOAP DISPENSER

AQE-ECO-251-XX
Brass
AC:220V
1.6-2L
100-3500cp(mpA·s)
≤2mL/times(four gears)
Model No.
Material
Power Supply
Bottle Capacity
Normal Temperature
Viscosity
Soap Volume
Ambient Temp.
Sensor Range
DC:6V (4xAA)
15±3cm
Specifications:
Installation:

FLOOR
Power Adaptor
Roughing in:
Wall

WALL
1. Fill the soap bottle with liquid soap for the first use.
2. Press and hold button until liquid soap is dispensed from the nozzle.
3. Place hand below the nozzle to dispense liquid soap into palm of hand.
The soap dispensers have 4 settings to adjust dispense of soap, the first gear
being the least volume and the fourth being maximum.
Factory default is set at second gear.
CARE AND MAINTENANCE
If the soap dispenser fails to function correctly, firstly check all connections are
tight and free from air leaks. If dispenser still fails to function, place manifold into
a bottle of warm water. Pump the warm water through the dispenser to dislodge
any dried soap residue and then refit manifold into soap bottle.
Water marks and soap residue on polished chrome surfaces are best cleaned using
warm water and a mild detergent. Use a stainless steel cleaner for brushed
stainless steel soap dispensers. Never use an abrasive cloth to remove stubborn
stains. Dry with a soft clean cloth.
first gear second gear
third gear fourth gear
Installation steps:

Note:

Note:

INE-ECO-251-XX-09-20
AQUAECO
WASHROOM AND PLUMBING SOLUTIONS