SATO STG112 User manual

Checking the Bundled Items
After opening the box, check that the following bundled items are
all present.
If anything is missing, inquire with the retailer, or dealer where th
is product was purchased.
First edition: Jan. 2019 Q05228600
©2019 SATO Corporation
Stacker
Media guide
Installation
Manual
Installation Manual
(This manual)
Stacker
STG112
Installation Manual
Thank you for purchasing the
STG112 Stacker (hereinafter referred to as “this product”)
for the
SG112
-ex at this time.
After
thoroughly reading this manual, please properly use this product.

CAUTION
・Set up this product on the same floor as the SG112-ex main unit so that the SG112-ex
and this product do not protrude from desks, etc.
・When setting this product on the floor or a stand, make sure not to get your fingers or
hands pinched.
・Do not carry this product with media loaded in it. The media could fall out and cause an injury.
・Be careful in handling this product so that injuries are not sustained from this product's
corners.
1．Set and install the Media guide hook on the SG112-ex’s Media discharge outlet.
Depending upon the media’s size, the Media guide does not need to be installed.
2．Adjust the position while pushing on the Media stopper’s [PUSH] section.
Match the lengths up to the Media stopper from the ends of this product to the lengths of the media.
3．Place this product in front of the SG112-ex’s Media discharge outlet.
At this time, set this product and the SG112-ex so that there is no clearance in between them.
* In this product the media is stacked up to a height of 35 mm.
Remove the media before it exceeds 35 mm. Not doing so may cause a media jam.
Installing this Product
Lengths of the media
Media stopper
Media guide