Sealey SM19.V2 User manual
PARTS CLEANING TANK
MODEL NO: SM19.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user’s responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood:
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
Important
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
DO NOT pull the plug from the socket by the cable.
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Cable extension reels
cable reel with an RCD fitted is recommended since any product which is plugged into the cable reel will be protected. The section of the
cores of the cable is important and should be at least 1.5mm², but to be absolutely sure that the capacity of the cable reel is suitable for
this product and for others that may be used in the other output sockets, we recommend the use of 2.5mm² section cable.
1.2. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
Familiarise yourself with the applications, limitations and potential hazards of the tank.
WARNING! Disconnect the tank from the mains power before changing accessories, servicing or performing any maintenance.
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
WARNING! DO NOT modify the lid or jam it open. Keep the lid and holding screws in place, tight and in good working order.
Locate tank in a suitable work area and keep area clean and tidy and free from unrelated materials. Ensure there is adequate lighting.
Ensure there are no flammable or combustible materials near the work area.
In case of fire in tank, DO NOT attempt to move unit or remove parts from tank. The lid is fusible and will automatically close extinguishing
fire.
When cleaning parts ensure that nothing in the tank, including any parts basket, is in a position that would prevent the lid from
closing fully if and when the fusible link activates.
WARNING! DO NOT SMOKE and keep sources of ignition, such as heaters, lamps, etc., away from the unit, together with flammable or
combustible materials, as there is an explosion risk.
WARNING!
gloves, to prevent the cleaning agent contacting the skin.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from the work area.
Avoid unintentional starting.
DO NOT overfill tank or allow fluid level to fall below pump inlet.
S
Original Language Version
© Jack Sealey Limited
Refer to
instructions
protection
gloves
footwear
clothing
Recommended fuse rating
DO NOT use the tank for a task it is not designed to perform.
DO NOT
DO NOT allow untrained persons to operate the tank.
DO NOT operate the tank when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT leave the tank operating unattended.
Dispose of waste liquids in accordance with local authority regulations.
WARNING! Protect the environment - DO NOT allow uncontrolled discharge of pollutants.
Keep the tank clean for best and safest performance.
2. INTRODUCTION
solvent over work. Supplied with workshop stand with integral storage shelf.
3. SPECIFICATION
Model no .................................................................
Supply............................................................................
Motor power ....................................................................
P..........................................................
O ..............
eight.......................................................................
Maximum working capacity .............................................
Minimum working capacity ..............................................
Solvent type ...................................................... water soluble
4. ASSEMBLY
Refer to attached Parts Diagram and List for item numbers.
Rest tank on a clean soft surface (i.e. cardboard) ensuring lid is secured in
the closed position.
but do not tighten.
but do not extend the lid too far.
Remove the self tapping screws from the cover plate of the pump unit (A) and check to see if there is any supporting packing inside. If so,
remove the supporting packing and replace the cover.
Place the pump into the tank unit and pass the switch unit through the slot in the cleaning tank side (A). As the unit protrudes through the
5. OPERATION
WARNING! Wear safety clothing, eye protection and gloves and ensure you read, understand and apply the safety instructions
in Section 1.
5.1. Ensure the unit is located on a firm level surface in a well ventilated area and is switched off and unplugged from the mains power supply.
5.2. must
instructions on the packaging.
Plug the machine into the power supply and switch the unit on. The cleaning agent will flow through the flexible tube.
before cleaning.
DO NOT leave the unit operating unattended. Check the fluid level does not fall below the pump inlet.
5.5.
Switch off the unit, close the lid and disconnect the unit from the mains power supply. Clean up any spillage.
Dispose of waste liquids in accordance with local authority regulations.
IMPORTANT! The cleaning tank has an anti-fire device built into the unit. In the event of a fire the lid will automatically close. DO NOT
prop the lid open as this will prevent the automatic safety feature from operating. Once actuated, the fire detection device cannot
be re-used and must be replaced before further use.
fully if and when the fusible link activates.
6. MAINTENANCEi
Clean the inside of the tank at regular intervals and keep the main body of the unit clean.
Regularly wash the pump filter in clean degreaser and replace if necessary.
Ensure that all screws and bolts are kept tight..
S
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
WEEE REGULATIONS
waste authority for recycling information.
S
Original Language Version
© Jack Sealey Limited
Table of contents
Other Sealey Industrial Equipment manuals
Sealey
Sealey AK459DX.V2 User manual
Sealey
Sealey AK468DXP User manual
Sealey
Sealey PT500.V2 User manual
Sealey
Sealey ADT7 User manual
Sealey
Sealey RE97XCKIT User manual
Sealey
Sealey hp5 User manual
Sealey
Sealey WS681.V2 User manual
Sealey
Sealey VS3847 User manual
Sealey
Sealey WS681 User manual
Sealey
Sealey PBS91.V4 User manual
Sealey
Sealey Quality Machinery HPT750.V2 User manual
Sealey
Sealey VS207.V2 User manual
Sealey
Sealey ADT200 User manual
Sealey
Sealey SSG1P/3.V3 User manual
Sealey
Sealey TBB230 User manual
Sealey
Sealey YK309FAH User manual
Sealey
Sealey HCC08 User manual
Sealey
Sealey BTR4.V2 User manual
Sealey
Sealey YK20F.V3 User manual
Sealey
Sealey APIC1800F User manual
