Sealey SCR02B User manual

PNEUMATIC CREEPER STOOL WITH
ADJUSTABLE HEIGHT SWIVEL SEAT & BACK
REST
MODEL NO: SCR02B
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
WARNING! Use the seat on level and solid ground, preferably concrete.
9Locate seat in a suitable working area.
9Keep the seat clean and tidy in accordance with good workshop practice.
8DO NOT use the seat for any purpose other than that for which it is designed.
8DO NOT stand on the seat.
8DO NOT use the seat outdoors.
8DO NOT get the seat wet or use in damp or wet locations or areas where there is condensation.
8DO NOT clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat.
8DO NOT exceed maximum capacity of 150kg.
2. INTRODUCTION
Four legged heavy-duty steel construction with a black powder coat nish for corrosion resistance. Strengthening ring and mesh insert for
stability, also acts as a foot rest. Ø410mm Swivel seat features pneumatic height adjustment (510 to 650mm), rotates fully through 360° and is
padded with back rest for extra comfort.
3. SPECIFICATION
Model No.:............................................................... SCR02B
Capacity....................................................................... 150kg
Height(s) ............................................................. 510-650mm
4. ASSEMBLY
4.1. Unpack all parts before disposing of packaging material according to local
recycling regulations.
4.2. Invert frame and t the castors to the leg bases. Note the location of the two
locking castors (g.1).
4.3. Insert gas strut into base frame
4.4. Place seat onto gas strut.
5. OPERATION
5.1. Once the stool is assembled, compress the height adjustment lever whilst the seat is unloaded. This will allow the seat to reach its
maximum height.
5.2. To adjust the height, pull the lever slowly whilst sitting on the seat. Release the lever when at the desired height.
6. MAINTENANCE
6.1. If in constant use, check the tightness of all fixings on a weekly basis.
6.2. The castor wheels are maintenance free; ensure they are always able to rotate and swivel freely.
6.3. Clean the seat cushion and trays with a moist cloth and mild detergent.
SCR02B Issue 1 04/12/19
Original Language Version
© Jack Sealey Limited
Refer to
instructions
g.1

SCR02B Issue 1 04/12/19
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.